Look on the lower end of the engine
Should have 2 mounting bolts
You have to remove the cross over section of the exhaust
disconnect the battery, pull the primary cover and remove the jack shaft, You will need a 1/4 Allen socket to get to the starter bolts. remove battery pos cable from starter and remove
Should be at the lower rear end of the engine Remove the - battery cableRaise and support vehicleRemove wires from starter solenoid at top of starterRemove starter mounting boltsRemove starter
If its anything like a 93 all you do is disconnect the battery, disconnect and mark for reinstallation the wires at the starter. Remove the two bolts that hold it, and drop it out. Make sure to hold on to any shims that might be there.
Here is a web site that I saw that will help you on removing and replacing the starter on a 1999 Toyota 4Runner: http://www.4crawler.com/4x4/CheapTricks/Starter.shtml
HOW TO REPLACE A STARTER ON A 1998 CHEVY MALIBU
locate starter, mark and remove wires, remove bolts, remove starter
Remove the positive cable from your 1998 Chevy Cavalier battery. Remove the cables from the front of the starter. Remove the starter retaining bolts. Reverse the process to install your new starter.
you need to remove the left primary case and remove the gear from the end of the starter shaft. then you can remove the mounting bolts and the starter will slide out.
Disconnect the - battery cable Raise and support vehicle Remove wiring at top of starter Remove starter mounting bolts Remove starter
Disconect the - battery cable Raise and support vehicle Remove wiring at the top of starter Remove mounting bolts Remove starter
Remove - battery cable Raise and support vehicle Disconnect wiring at top of starter Remove starter mounting bolts Remove starter
you have to go to the car fix to remove it
The starter on a 1998 Toyota 4runner is held located on the transmission housing. The starter is held on by 2 bolts which mount it directly it the engine. Remove the two bolts to replace the starter.
YOU FIRST HAVE TO DISCONNECT YOUR BATTERY. # Remove air duct assembly. # Disconnect starter harness. # Remove starter bolts (two). # Remove starter. #
Remove the positive cable from your 1998 Monte Carlo battery. Remove the cables from the front of the starter. Remove the starter retaining bolts. Reverse the process to install the new starter.
You have to remove the cross over section of the exhaust