0
Standard is 17t
Wiki User
∙ 12y ago
Add your answer:
Earn +20 pts
How many teeth on a stock sprocket for a 2005 banshee?
The front sprocket has 14 teeth. the rear has 41 teeth, but on mine i have 13 front and 42 rear its more bottom end performance
Remove front chain sprocket on 1983 Honda ATV big red 3 wheeler?
Take off the chain and then there should be 2 little bolts holding on the sprocket. Remove those and then rotate the sprocket slightly so its teeth line up with the teeth on the output shaft and it will slide right off.
What size sprocket is on the rear of a suzuki bandit 1200s?
The chain is size 530, and the stock gearing is 15/45, meaning that the front sprocket has 15 teeth and the rear sprocket has 45 teeth.
How many teeth are on a trx 450r front sprocket?
on an 2005 trx450r there are 12 teeth on the front sprockeet and 37 in the rear
What is the size of the stock sprokets on a 1991 Honda nighthawk?
I have a "Clymer Honda CB 750 Nighthawk 1991-1993 & 1995-1999" book. It says for sprocket sizes, "Drive Sprocket 15 teeth, Driven Sprocket 38 teeth". Nothing else listed in there or in the Owner's Manual as to size.
What is the sprocket size on stock 2004 gsxr 600?
16 teeth in the front 45 teeth in the rear
How can you make a 110cc 4 wheeler get faster It's chain driven?
More teeth in the front sprocket and less teeth in the back sprocket. You can also add performance exhaust, and take the governor out.
How can you make a 110cc 4-wheeler get faster It's chain driven?
More teeth in the front sprocket and less teeth in the back sprocket. You can also add performance exhaust, and take the governor out.
How fast is the top speed of a 2013 Honda trx250x ATV?
This vehicle will go 45 to 49 mph maximum in its original condition. If you want to increase the speed, change the sprocket ratio. Get a smaller rear sprocket, minus four teeth, and a bigger front sprocket of plus two teeth, then get a larger carburetor and you will gain perhaps five to ten miles per hour. But be careful when ridin in rough terrain at high speed.
Prewar western flyer bicycle?
If it is pre war it will have spaced out teeth on the front sprocket, this is typical on all pre-war.
What is that suppose to mean on a 1998 CBR 600 The bike is geared one tooth down in the front and up two teeth on the rear?
The front sprocket on the engine that the drive chain goes round has approx 16 teeth. To drop it down you remove the sprocket and replace it with a 15 tooth. same idea on the back but up 2 teeth which makes the sprocket larger. Reducing the size of the front and increasing the rear will improve acceleration but will have slower top end, usually makes for better low speed handling too.
What are teeth on bmx?
In the drive train you have the front chainwheel/ring and the rear sprocket that both engage the chain. The pointy bits on sprocket and chainwheel which allows the chain to grip are called teeth. The ratio between the tooth counts is what determines which gear ratio the bike has.
