Turn it all the way in and then back out 1 1/2 turns
The only setting is one screw on the top of each carb its the mixture screw and should is 1.5 turns out by default.
3 turns out..
1 and half to 2 full turns
Turn them fully in and then 1 1/2 turn out. This will allow you to start the engine and fine tune them from there.
Depends on the year. My 1996 is 122 mainjet, 55 pilot, mixture screw two turns out from closed. Clip is on the third setting for the needle.
you have to pop out the washer looking plug on the bottom front of the bowl and you can accsess the mixture screw. but you might have to lossen the carb and twist it to one side or the other to do this. then start with half out turns at a time . but without rejeting you aren't going to improve much
yes a mochalate is a mixture because the mochalate has two or more subtances in it so when they all combine it turns out to be a mixture
1 and half to 2 turns ( full turns) no more then you`ll start to run lean
the mixture turns black
Three turns out from all the way in will get you close
Try 1.5 turns out on the mixture screw for an initial setting.
turn in then 1 1/4 turns out on high and low factory settings hope this helps