Just use Ohm's Law: V=IR (voltage = current x resistance; using units: volts = amperes x ohms).
Using Ohms law, the resistance can be calculated by using the following formulas. R = Watts/Amps (squared). R = Volts (squared)/Watts. R = Volts/Amps.
On this calculation I am assuming that the light bulb is using a 120 volt source. Watts = Amps x Volts. Amps = Watts/Volts, 40/120 = .33 amps. R = Volts/Amps, 120/.33 = 363.6 ohms resistance in the 40 watt light bulb.
Amps are units of current, watts are units of power. Watts are the product of Amps times Volts. Watts = Amps x Volts.
That depends on what units you use as input. If you put in current in Amps and Resistance in Ohms you will get voltage in Volts.AnswerCurrent is measured in amperes. Resistance is measured in ohms, which is a special name given to a volt per ampere. Multiply amperes by (volts per ohm), and you are left with volts.
Ohm's law states that you could calculate the current (Amp), resistance (Ohm), or voltage (Volt) as long as you know the other two. Watts is not part of this law. Therefore, your question does not give enough information.
16 volts
Amperes does not convert into volts they are two different values. Become familiar with the following formula and look at the relationships between the values. Volts = Amps x Resistance, Amps = Volts / Resistance and Resistance = Volts / Amps.
You use Ohm's Law to make your calculation. Volts = Amps x Resistance Amps = Volts / Resistance
voltage is equal to resistance multiplyed by current. you have the 2 pieces of info, just multiply
Amps and volts are not the same, but related by Ohm's Law. Volts = Amps x Ohms. Ohms is a measure of resistance. Given .01 amps you would have to know resistance to calculate volts.
The equation that you are looking for is I = E/R. Amps = Volts/Resistance.
At 110 volts it is 0.8 amps. At 220 it is 0.4 amps. I=E/R. I=amps.E=volts R=resistance.
The formula you are looking for is R = E/I. Resistance = Volts/Amps.
With an instrument called a multimeter. The single meter incorporates within it a volt meter, an ohm meter and an amp meter. For higher amperages a clamp on amp meter is recommended as the circuit does not have to be opened to take a reading.
Current is inversely proportional to resistance. If you double the resistance, you halve the current. Ohm's Law: Volts = Amps * Ohms Solve for Amps: Amps = Volts / Ohms
You use an "amp gauge" to measure amps in an actual circuit. It is hooked in series with the load. It can be placed anywhere in the circuit as long as it is hooked in series. Mathematically, you have to know the resistance, or wattage and voltage of a circuit. Volts=amps*resistance or amps=volts/resistance, or resistance=volts/amps. Ohms law!
Use Ohm's Law: V = IR (voltage = current times resistance).