0
How many watts can the Kicker 08DS12L72 Dual 12 in. 1500 Watts Enclosed Car Audio Subwoofer handle?
Wiki User
∙ 14y ago
The Kicker 08DS12L72 can pump out up to 1500 Watts, but you'll need a beefy receiver for that.
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
What is better the kicker solo x or jl audio w7?
The solo x is a bad subwoofer it can handle a lot of wattage and will break windows. JLs is a good sounding sub but probably cant handle as much wattage as the solo x
Is a butterfly knife a concealed weapon?
Technically yes, because its enclosed inside the handle its considered concealed.
What will happen if you hook up a 2-Ohm Car Subwoofer to an 8-Ohm Home Receiver I have a Kicker Comp 12 2-Ohm Subwoofer so I was wondering if I could hook it up to my 8-Ohm Home Receiver HELP?
If your home receiver is not rated for a 2-ohm load (many can handle a 4-ohm, but not a 2-ohm), you will damage components inside the amplifier by over-current. Don't use car stereo components in home stereo equipment. It's like using a hockey helmet to ride a motorcycle.
Will a 1600 watt amp blow a 450 watt sub woofer?
Well, it depends. When you look at subwoofers, it will say RMS and peak. Now, let's talk about the "RMS" and "peak" on the subwoofer. The RMS is the real power. That's what were gonna be looking for. The RMS is the continuous power design for the subwoofer to operate. The peak is the maximum power the subwoofer can handle. Obviously, were not gonna be running the subwoofer with its peak power because that will decrease the life of your subwoofer. Running too much power or too little can damage your subwoofer. It's also important to run it by it's RMS rating. So, I don't know if that 450 watt is the RMS or peak. I'm assuming that it's the RMS. As long as you don't bridge it, it should be fine.
What size amp should you get if your getting a 12 alpine type-x?
well each type x subwoofer can handle 3000 watts max and 1000 rms (recomended) so about a 2000 watt amp should give u unbelievible bass, if u have 2 alpine type x 12's u need can handle 6000 watts and 2000 rms
How many watts can the Rockford Fosgate Prime 2-Channel Car Amplifier handle?
The Rockford Fosgate R150-2 2-channel amp puts out 50 watts RMS per channel to your speaker system, or you can bridge it to supply 150 watts RMS to a subwoofer.
What kind of temperature do canaries like?
Canaries like moderate temperatures. Room temperature is fine. They can handle cold temperatures as well, as long as they are not in a draft. I kept my birds on an unheated enclosed porch with great success. I brought them inside for breeding.
Can you use car subwoofer with your home stereo?
You need to make sure the impedance matches or you will blow you amplifier! It would be best to replace it with the same brand as the speakers, feed it with a digital cable. There won't be a problem of overloading your amplifier.
Will a 1200 watt amplifier blow out a 1000 watt subwoofer?
Technically, yes. Practically, no. Amplifiers and speakers are rated by the maximum amount of power (and at what impedance) they can handle. A 1200 watt amplifier will eventually destroy a 1000 watt speaker if it is operated at maximum power. In normal use, however, you rarely even get close to maximum rating.
How do you replace outside drivers side door handle on 1995 corolla?
First remove the door panel and all of the trim pieces.Unbolt the cross brace that goes over the window regulator dole in the door.Reach in and disconnect the latching rods from the door handle.Remove the two 10MM bolts from the inside of the door that hold the door handle on.Then remove the key lock.The outside door handle should now come right off.A step by step instructional video has also been enclosed below, that explaines this whole process.
Can 100 watts amp handle 300 watts subwoofer i have a pioneer 300watts sub and a 100 watts rockford amp will the amp handle it or it will get fry?
An amp can only put out so much power without distortion. A speaker, say, a subwoofer, will utilize whatever the amp is able to put out. So the question is not will a speaker fry an amp, but whether the amp will blow the speaker. (Not, in your example) Any speaker, though, needs a certain amount of power to begin to drive it to listenable levels. High-efficiency speakers like bass-reflex speakers need only 5 or 10 watts for loud levels, while a low-efficiency speaker may not even make a squeek until they are fed with 10 to 15 watts of power. sO will this set up work or not?
What are the types of hacksaw handle?
file or straight handle, pistol grip handle and woodsaw handle
