for a large one it is 4,000 watts and for a smaller one it is 1,000 watts
Edenpure heaters produce 1500 watts. It is an electric heater, which uses quartz heating element to generate heat.
The electric heater will have power rated in Watts. The Amps it will draw depends on the voltage system you are using. Can be calculated by formula I (Amps) = P / V In the USA with 110V system a 2400W heater will draw 2400 Watts / 110 Volts = 21.8 Amps In Australia with a 230 V system a 2400W heater will draw 2400 Watts / 230 Volts = 10.4 Amps
An electric toothbrush has 2-4W (watts).
An electric water heater in a hot tank is called an immersion heater and many of those run at 3 kW with a thermostat to control the max temperature. Power showers use a type of water heater that heats the water at the point where it is used, without a tank. They run at 6-8 kW and are also controlled by a thermostat.
Depends on the Amperage of each baseboard heater (how many watts each one draws).
1300/1500 watts
Do you mean how many watts are used to make hot water? It varies, but a typical home electric hot water heater consumes about 4,500 watts. Industrial hot water heaters might use 20,000 watts or more! I have a little warmer that keeps my coffee warm as I type this, it consumes about 300 watts. Of course it only heats 6 ounces of water....
Different 240 volt watt water heaters use different amounts of watts! Look at your water heater. It should have a plate that lists the watts! On the other hand, the water heater only uses watts when it is heating water. If the family uses paper plates and takes brief showers by getting wet, turning off the shower, applying soap, and then rinsing, it will use a lot less electricity than if every member of the family runs out the tank of hot water taking a hot shower every day.
100
The GE water heater SE50M12AA01 is a 5500 watts or 5.5 Kilowatts water tank. The amperage on such a tank is I = W/E. Amps = Watts/Volts. Since most hot water tanks in North America use a voltage of 240, the amps will be 22.9 amps. It must be fed with a #10 conductor from a 30 amp breaker.
It uses 1150 watts, or 10 amps.
microwave: 700W (2000cc water load) convection heater: 1450W