0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
How are Ethernet cables made?
Ethernet cables are made from cat5e cable. This cable is designed for carrying signals and is commonly used in networking. It is made up of several multicolored wires which carry the signal. This cable must have Ethernet Connectors on both end to enable to to be plugged into a router or modem.
What carries information in the form of electrical sighals?
Signal curcuits are used for many different purposes. Wires carry electrical signals.
Why are there 8 wires in an Ethernet cable?
In Cat 5 cable based on fast ethernet (100 mbsp) 4 are used to Send and Receive. The other 4 wires are unused. All 8 wires are used for gigabit communications.
How do you hook a amp to a aftermarket radio in a 2002 Tahoe?
Amplifier instalation is the same as any-- power wire, ground wire, wires to subwoofer. The "tricky part is taping into existing wires to get the required input signal and the remote signal to switch the amp on and off.
When the signal from one pair of wires interfaces with the signal on another pair of wires?
Near end crosstalk
Why thin wires are used?
Wires are sized depending on the amount of amperage they are expected to carry. High current required a large size wire and hence small amount of current only needs a small wire.
How audio and video signal travel bidirectional in one cable?
It depends on the architecture of the cable but the most common is multiple wires in the cable, you only need two wires at a minimum to communicate, one as a ground or base, and the other to for the signal. The devices can also take turns communicating, allowing for two wires to be enough. An example of a two wire cable is the typical headphone cable, though it is in a single direction. Four wires allow for two way communication, one set for transmit, and one for receive, which on the other end the transmit wires become receive, and the receive wires become transmit. A typical example is the Ethernet cable which your computer is most likely connected to the internet with.
Why do wires use metals?
The purpose of a wire is to carry some sort of electrical signal. This requires that the electrons in the material be able to move freely. Materials with free movable electrons are called "metals".
How does one make an Ethernet crossover cable?
An ethernet cable splitter allows one to connect two computers to one cable. First, strip the ooating off the end of the cable wire. Second, untwist the wires inside. Third, connect the wires using an RJ45 connector.
What is the twisted wire pair?
Ethernet cable. 8 wires in 4 pairs. The wires are twisted around each other and covered with a plastic tube to help prevent interference. The wires are also each in plastic.
What are ethernet cables?
Ethernet Cables are cables with 4 or eight conductors that connect to an RJ45 connector on both ends. They come in a variety of colors and must be no longer than 100 Meters. 10BaseT and 100BaseT use pins 1,2,3 & 6 GigE uses all 8 wires. Generally all current Ethernet cables come with all 8 wires now.
What are the different types of household wires called?
general purpose of wire is to transmit power or signal in to receiver side the following are the classifications of wire Signal wires Power wires Co-axial wires
