Want this question answered?
In Full bore ball valve, The bore dia will be same as internal dia of the pipe.In reduced bore, the bore dia is reduced than the ID of pipe.
Generally speaking, gate valves in larger sizes are full bore unless you order a reduced port. You would always use a full bore gate valve for hot tapping purposes. or you would use a full bore gate vale for runinig a pig in pipeline.
I found it out its a Full bore gate valve
Use full bore for applications where pressure drop should be minimum (such as in the suction pipe of a pump with required NPSH very close to available NPSH), or for pipes which could be cleaned with a pig (so that the pig doesn't get stuck on the valve). In other applications a reduced bore should be OK.
valves are available in three types first is full bore equal to 100 percent opening normal bore/port equal to 80 percent opening reduced bore equal to 60 percent opening
DON'T!! Dry the engine out first. If you try and start an engine full of water you will blow it. After it is dry, start it like you normally would.
yes and no, there stomach can blow up from being to full,but i don't think you can litterally "BLOW UP".
For Ball valve only,as it gives more full bore flow,unlike wedge block,slow operating in Gate valve.
It didn't blow up. It's still there and in full working order.
It can, but you will probably get better accuracy with improved cylinder bore or cylinder bore using slugs. It depends on the gun.
Injection Stretch Blow Molding
Mic the ID of the muzzle compared to the ID of the unchoked bore. Most of these guns will be Full/Modified or Full/Full. sales@countrygunsmith.net