Want this question answered?
Voltage and resistance determine amperage, assuming the source can provide the amperes.
A voltage and amperage need to be stated to answer this question.
A GFCI trips when it detects a difference in the amperage going to the outlet and what is coming back. Even 4-6 miliamps difference will trip the outlet.
30 gauge wire is much "thinner" than 10 gauge wire. Hence, if you are using 10 gauge for an application requiring only 30 gauge, it will more than handle any current flow. However, if the application requires 10 gauge wire you cannot use 30 gauge wire.
Need to know the voltage of the motor. Use this formula, I = W/E, Amps = Watts/Volts. Once you have the amperage then ask, what size wire is needed for (your amperage) at (your voltage).
2 amps
the gauge of the wire determines how much amperage a wire can carry the insulation determines how much voltage the wire can handle
How much amperage for a hotpoint 20 inch stove
Voltage and resistance determine amperage, assuming the source can provide the amperes.
Circuits are limited for a few reasons firstly because certain size wiring can only handle so much voltage and amperage before it could fail secondly wiring heats up when more amperage is drawn through it which can create fires or burning out of the circuit most appliances draw set amount of current and amperage if you have a low amperage appliance Eg pool pump drawing 4 amps and the windings start to fail the motor can start drawing excessive amperage creating a hazard, if you had a large circuit it may never trip the breaker indicating a fault with the appliance which can cause catastrophic failure.
To answer this question the motor voltage is needed.
I paid $89 for a thermostat and $98 for labor
A voltage and amperage need to be stated to answer this question.
How much does it cost to fix the thermostat housing for a ford explorer sport 4.0 6 cylinder
About $ 10.00
About $9.00
Digital electronics devices handle numbers in the form of the binary system. That is, the numbers are represented in base-2, with only two digits. That way, when a digit comes along, it's much easier for the electronic device to decide what digit it is.