answersLogoWhite

0

How much amps used in 5kv ups?

User Avatar

Anonymous

14y ago
Updated: 8/19/2019

It depends on how many volts there are.

User Avatar

Wiki User

14y ago

What else can I help you with?

Related Questions

What do electric guitars play through?

pick ups and amps


What is the amps of a 650 VA UPS?

To answer this question the voltage of the UPS has to be stated. Take that voltage and divide it into the 650 rating. The answer will be the output amperage of the UPS.


How calculate ups battery backup time?

The UPS should be rated in Amps per Hour. Just divide that number by the current requirements of the device connected to the UPS. Say that the UPS is rated for 10 Ampere Hours and your device draws 2 amps. You could run the device for about 5 hours.


Can you drive 1.5 ton ac on hmx 5001 homage ups?

That UPS can deliver 4.5 kW (230 v, 21 amps) while a typical 1.5 ton aircon runs at 1.8 kW, 220-240 v, 9.5 amps, which is ok.


What size of a ups would you need to handle 20 watts?

UPS batteries are typically rated at how many ampere hrs they can supply. IF your 20 Watt device is supplied by 120V then it draws 1/6 amps. (Watts = Amps * Volts for a resistive load). If your UPS were rated for 1 A Hr you could power your device for 6 hours.


How much electricity consumed by 20 KVA Ups in one hour?

When running normally a UPS has a battery on float charge and there is very little 'lost' energy, I would guess 1-3% of the rated power of the equipment, so that is a power of 60-180 watts - just my guess.


What two measurments are used to rate the capacity of a UPS?

VA and AMPS IS WRONG! For the A+ test it's : Ohms and WattsThe answer is. VA and wattsThanks!


Two measuremnets to rate capacity of UPS?

1) Rated Protection of the UPS 2) Run Time. Rated protection is usually in KVA or VA (KilliVolt amps for very large UPS or Volt Amps for smaller UPS). This is because UPS typically have multiple outputs like 120V 240V and possibly 12VDC. Some only list WATTS. This assumes the UPS will have only one Voltage output so the Volts X Amps=Watts was already calculated. There is also something called a "Power Factor" that comes in to play. For computers it is ~60% which means if you are backing up a PC it will take more power than you think or the UPS will run for less time than you think because of the power factor. Runtime is usually presented in a chart since it will vary based on the load it is supporting. A battery has a rated Amp/Hour capacity. Amps per hour. You use a fraction of this over time until there is no more energy. Using Ohms Law you can determine the Amps from Watts or KVA/VA. P=IxE or Power ( watts) = Current( amps) x Electrical energy ( Volts) So I (amps) = P(watts) / E ( volts) . There are other factors like the battery charge level, ambient temperature and losses in cabling etc, that affect the run time in amp hours.


How much does a ups truck weight?

Ups truck


What rating is used to specify the size of a ups for computers?

Voltage & Amperage, Volt & Amps, V/A. All of those are the same written different ways, to give a understanding for those at the most basic level. ~Chute~


What are two main types of ups?

Types of UPS1. Standby UPSStandby UPS is then used. When the power supply shuts down. Then it supplies the consumed power to the computer when the power is off. In which the computer's data is safe.2. Line Interactive UPSDesigning a Line Interactive UPS is similar to a standby UPS. It is a combination of both UPS online and offline. This UPS is used for small businesses. And at the same time it controls the electrical effect of the UPS output.3. Standby Online HybridStandby on-line hybrid is a topology used in UPS under 10 kva. Which is switched on from battery to standby converter. The battery charger is much smaller than it is in Stand by UPS


Full load current of 5 KVA UPS?

the full load efficiency is more than 91%. it switches to green mode when it does a 97 % I have no idea what the answer above means. If you are talking about a 120 Volt system it would be 41.67 Amps. How long the UPS can deliver the current with no supply voltage would also be a question and should be part of the rating of the UPS in Ampere hours or Milliampere hours.