2X the joint thickness. Maybe
what characteristics does the weld bead have when weaving the electrode
Pitch is center to center spacing of an intermittent weld.
When the depth of filling is less than the thickness (less than complete), it is specified inside the plug weld symbol!!!
formula for a 6" 45 degree lateral onto a 6" main
in weldi ng the angle is pretty important, too much of an angle will lead to lost filler. a smaller angle (where you are pushing the electrode) causes a wider weld bc. of it relation to the pool. pulling it (larger angle) creates a thinner, taller weld. you would need to practice to see
27.5 degrees
flat
Flat position welding is when your job is in a horizontal position the easiest and best position to do welding, then you get vertical up position where the trick is to weave your arc in a V formation, vertical down is used on thin material if its possible at an angle of 45 degrees last overhead that is the most difficult the opposite of flat welding where the job is upside down anytime you look directly down on your weld joint, it is a flat weld, flat position weld are not affected by gravity, as opposed to horizontal, vertical, and overhead, all of which the puddle tends to "sag" as you weld
2X the joint thickness. Maybe
The 'face' of the weld may be slightly convex, flat, or slightly concave.
what characteristics does the weld bead have when weaving the electrode
A fillet weld is the joint of 2 pieces of material, usually at a 90 degree angle. see http://www.unified-eng.com/scitech/weld/fillet.html
minus weld gaps and takeoffs from total then multiply for angle.
A fillet weld is the joint of 2 pieces of material, usually at a 90 degree angle. see http://www.unified-eng.com/scitech/weld/fillet.html
Welding is not allowed by the NEC (United States' code).
The angle of the electrode, the speed of the electrode used to weld and the size of the electrode.