0
How much concrete mix use in 5 cubic meter 1 bucket cement 4 bucket sand 8 bucket 40mm metal?
Wiki User
∙ 10y agoWant this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
How do you remove bolt anchors from cement?
Normally you have to cut them off with a grinder. A grinder with a metal cutting blade will allow you to take them down flush with the concrete. Wear eye protection though it does throw lots of sparks and some concrete.
Why concrete is strong in compression and weak in tension?
Concrete is strong in compression, as the aggregate efficiently carries the compression load. However, it is weak in tension as the cement holding the aggregate in place can crack, allowing the structure to fail. Reinforced concrete solves these problems by adding metal reinforcing bars, glass fiber, or plastic fiber to carry tensile loads
How do you strengthen concrete?
you could strengthen it by putting metal bars inside the concrete
Difference between ordinary Portland cement and puzzalona Portland cement?
OPC - Ordinary Portland cementOPC - Materials used - Argillaceous and calcareous materialsPPC - Portland Pozzolona CementPPC - OPC + Pozzolonoc materials(fly ash, volcanic ash, pumicite at the time of grinding).
Why do builders put metal rods in concrete?
Rebar is used as a tensioning device in reinforced concrete and reinforced masonry structures holding the concrete in compression.
What is the use of RCC?
RCC that is reinforced cement concrete which is composed of cement(mainly),sand(fine aggregate),metal(coarse aggregate)and water.Which is further more supported by iron which makes it RCC from ordinary cement concrete.
How do you calculate the amount of cement sand and blue-metal to lay 100 square feet reinforced cement concrete?
for 100sft or 100cft
What is a cement anchor?
A cement anchor is a general term to describe a fastner that is attached to concrete. Common concrete anchors have a lead tip that mushrooms and "grabs" the concrete. Usually a hole is first drilled into the concrete. Then a concrete anchor is driven into the hole using a hammer. This allows for attaching wood or metal to concrete.
Is concrete a metal nonmetal or metalloid?
No. Concrete is a mixture of cement and other elements. Reinforced concrete often includes iron or steel beams in it to make it stronger.
How do you dissolve concrete?
One inche metal pipe is filled with cement contrere and it has many curves. How can i clean that pipe
What can a metal bucket be made out of?
A metal bucket is made out of metal
What is the different between ordinary Portland cement and Portland cement?
Ordinary Portland cement is the most common cement used in the world, made from stucco, concrete, mortar and other materials. Slag cement is usually mixed with Portland cement and is the substance leftover after metal has been smelted from raw ore.
What is the process of calculating quantity of cement sand metal in concrete mix design?
Choose the grade of concrete & assume minimum water/cement ratio.Conduct some initial tests on the materials like cement, sand & metal(coarse aggregate).Tests like UNIT WEGHT, SPECIFIC GRAVITY,SIEVE ANALYSIS,SLUMP CONE TEST & COMPACTION FACTOR TEST. According to the obtained results do the mix design from IS CODE of IS800-10262 check for water cement ratio & calculate the quantity of cement, sand & coarse aggregate.
How do you remove bolt anchors from cement?
Normally you have to cut them off with a grinder. A grinder with a metal cutting blade will allow you to take them down flush with the concrete. Wear eye protection though it does throw lots of sparks and some concrete.
This hard rock is useful in building bridges and building what is it?
many have been used, but reinforced concrete is preferred now as properties are more predictable and consistent.
How do you Make ice with fertilizer?
all you have to do is put the liquid fertilizer in a bucket and put water in a metal bowel in the bucket
Why is concrete in compression and weak under tension?
Concrete is strong in compression, as the aggregate efficiently carries the compression load. However, it is weak in tension as the cement holding the aggregate in place can crack, allowing the structure to fail. Reinforced concrete solves these problems by adding metal reinforcing bars, glass fiber, or plastic fiber to carry tensile loads
