Want this question answered?
Yes, in a saturated copper sulfate solution.
It will darken the copper (II) sulfate solution.
16.67
a copper sulfate solution it becomes copper (II) sulfate pentahydrate
Copper can be obtained from copper sulfate solution by electroplating it onto an electrode or by adding a metal higher in the electromotive series than copper, such as iron, to the solution. The more active metal will dissolve by displacing copper in metallic form from the copper sulfate.
Heating the saturated solution of Copper sulfate will not form the hydrated copper sulfate crystals because only after cooling down the saturated solution of copper sulfate then only the crystals of the hydrated copper sulfate can be formed
Yes, in a saturated copper sulfate solution.
boil off the solvent (usually water) until you are left with copper sulfate crystals. For getting back the copper sulphate crystals from copper sulphate solution, we have to first make super saturated solution by boiling, then allow to cool down & dried these crystals with filter paper.
The pH of a copper sulfate solution depends on its concentration. Typically, a 1% solution of copper sulfate has a pH of around 3-4, making it acidic.
It will darken the copper (II) sulfate solution.
Copper II sulfate solution has a boiling point of 150 degrees Celsius. CuSO4 crystals melt at 200 degrees Celsius however I'm unable to find data on its boiling point.
16.67
a copper sulfate solution it becomes copper (II) sulfate pentahydrate
Copper can be obtained from copper sulfate solution by electroplating it onto an electrode or by adding a metal higher in the electromotive series than copper, such as iron, to the solution. The more active metal will dissolve by displacing copper in metallic form from the copper sulfate.
A cooled saturated solution of copper chloride will precipitate crystals of copper chloride.
You will have to assume that the 2 % is a volume fraction, then the volume of copper sulfate in the solution would be 11.5 milliliter(575 ml*(0.02). If it were a weight fraction, then you would have to have more information on the solution density.
The iron will react with the copper sulfate, producing iron sulfate and elemental copper.