Want this question answered?
Load Bearing - something that bears a load. Like a load bearing wall in a house. The wall is holding something up like the roof, another floor, etc.
An ambitious and dedicated civil engineer with strong practical technical skills and a range of experience within construction engineering and project management. Having a sound knowledge of designing, testing, evaluating a designs overall effectiveness, cost, reliability, and safety.
what is the load bearing weight for a 2x6x10
Non load bearing walls are walls that the weight of the roof is not supported on. Any wall that runs parallel will roof joists will be non load bearing.
The denser the styrofoam, the greater it's load bearing ability.
Center of a structure is usually load bearing. Look in attic or basement to see where the support is.
You will want to bring in a licensed carpenter and perhaps a structural engineer.
Lath and plaster is just an old type of wall finish. Like drywall is a wall finish. What the wall is constructed of underneath the lath and plaster and where it is placed in the building determine if it is load bearing or not. A lath and plaster wall could be load bearing or it might not be. IF it is an outside wall, it most certainly is load bearing. other than that, the best way to figure it out is to have a structural engineer tell you wether it is or not. Even if it is load bearing it may be possible to remove it if a beam is put up in place of the wall. Really, the best and safest way to decide is to have a engineer look at it.
A wall bearing no load.
The placement of steel reinforcing is dependent on the requirements of the strength and load-bearing of the concrete. A structural engineer should be contacted in this regard.
Load Bearing - something that bears a load. Like a load bearing wall in a house. The wall is holding something up like the roof, another floor, etc.
Usually, a load bearing wall will be perpendicular to the roof ridge.
You must temporarily support the framing above on each side of the wall, then emplace an adequately sized header to support the load, and transfer that load appropriately. Contact a qualified carpenter or seek the advice of a structural engineer.
what is the load bearing weight for a 2x6x10
Capability of sustaining the imposed load ....
An ambitious and dedicated civil engineer with strong practical technical skills and a range of experience within construction engineering and project management. Having a sound knowledge of designing, testing, evaluating a designs overall effectiveness, cost, reliability, and safety.
Non load bearing walls are walls that the weight of the roof is not supported on. Any wall that runs parallel will roof joists will be non load bearing.