0
How much does it cost to replace the ball joint on a1995 mercury villager?
Wiki User
∙ 11y ago
That is difficult to answer since shop costs can vary widely. This vehicle should have the wheels aligned after a ball joint replacement as well, so I'd expect to pay over $200 for the repair.
Wiki User
∙ 11y ago
Add your answer:
Earn +20 pts
How do you change the cvc joint in a 2000 mercury villager?
It is easier and cheaper to replace the entire axle. About $80.
How do you replace a CV joint 1993 Mercury Villager?
The CV joints on a 1993 Mercury Villager can be replaced by removing the front tires and the brake caliber. Next, the rotor, tie rod, and bottom ball joint must be removed. Then, a pry bar can be sued to pry the CV joint away from its housing.
What is the torque spec for right front cv joint1998 mercury villager?
The CV joint stud should be tightened to at least 220 ft/lb.
How do you replace lower ball joint on 93 Mercury Cougar?
Remove the tire and wheel from your 1993 Mercury Cougar. Remove the ball joint retaining nut. Pound the ball joint out with a hammer. Reverse the process to install your new ball joint.
How do you replace the back 3 spark plugs on a 99 Mercury cougar 2.5L v6?
same way as you replace the front three. You may need to move 1 or 2 components to access them, and you will probably need an extention and universal joint, or wobble joint.
Replace cv joint on Lincoln LS?
don't replace the joint. replace the axle
Why does your 1997 mercury villager make clinking noises as you drive it down the road It sounds like its coming from the drivers side front end Thanks?
Probably the CV joint on the drive axle. Have it replaced before it drops out from under the car.
How do you change ball joint on 1993 mercury villager?
to remove ball joint, take cotter pin out undoe nut hit side of ball part of ball joint with a heavy hammer, the ball joint will loosen. f ball on botton side , when hit with hammer it will just fall out then then unscrew othe end if tie rog end, make sure you count the number of turns to unscrew it to replace wind new one back on same number of turns and then continue opposite of removing, except you wont need a hammer if done right you will not need a front end alignmant
Is the engine a free wheeling engine?
Yes, the Mercury Villager and Nissan Quest engine, 3.0L and 3.3L, are all freewheeling engines at the insistance of Ford to enter into the joint venture program. The Maxima and Pathfinder with the same engine remained non- freewheeling (interference engines). I work for Ford and worked on the Villager program from 1989 to 2002 and was personally involved in the development of this program.
What causes a clunking noise from under the driver's side of a 93 Mercury Villager with 150 K miles when driving at any speed?
Check the strut or the C-V (Constant Velocity) joint if the noise is in the front. Stablizer link or ball joint would also be points of concern. possibly check the outer tie rods
How do you replace a CV joint on a 1992 Chevy pickup?
how do you replace a CV joint on a 1992 Chevy pickup?
How much does it cost to replace the CV joint for a mercury mountaineer?
It all depends on whether you want to do it yourself or pay a mechanic. The cv joints in my impala were 160 for both with me replacing them.
