This is a completely unanswerable question, as it depends on several factors: the composition of the steel in question (there are a great many different alloys that go under the colloquial name "steel"), the type of force being applied (tension, compression, etc.), the design geometries of the object in question, and the environmental factors around the steel (primarily, but not exclusively, the temperature)
Roman Dent is 6' 1".
Dent Blanch's height is 14,291 ft.
I believe "dint" is more commonly used as a verb, and "dent" as a noun.
Eddie Dent was born December 8, 1887, in Baltimore, MD, USA.
Tennessee State.
You can mark or slightly dent steel with a brass punch, but the steel is always going to win.
No, silver will not shatter, but the item could bend or dent.
Yes and No depending on the pureness of the silver. The more pure the easier it will bend the less pure the harder it will bend.
It is malleable so it would bend or dent.
Some say that working on a steel car is a lot less messy or difficult than working on a fiberglass car. This is due to the tools and knowledge required to work with steel vs fiberglass.
Remove the bumper cover (mounted using a combination of snaps & bolts). Apply a force to each dent in the opposite direction of the force causing the dent. The dent area will often pop back into its original position.
If the appliance is stainless steel, a scratch can be improved by using a stainless steel scratch removal kit. Scratch-B-Gone, and Rejuvenate Stainless Steel Scratch Eraser Kit are both products that can improve the appearance of a scratch or dent in an appliance.
Under normal circumstances, water cannot dent or bend metal. However, water can cause metal to corrode or rust over time, depending on the type of metal. This corrosion weakens the metal and may eventually lead to deformation or damage.
John Dent Dent was born in 1826.
'Dent' is the correct spelling of the word 'dent'.
It is not possible to blast a hole in 2 inch steel plate with a 12 gauge slug. The slug will barely dent the plate, if it does anything at all.
Yes it is. One disadvantage of it is that it can't be cut. If you have a ring made of titanium you can't size it. An advantage of it is that it doesn't dent, scratch, or bend and stays shiny.