biusxx123
This is dangerous and must not be done.
On a completely empty system that has been flush out, it will hold 10 ounces of oil and 1 pound and 14 ounces of R134a freon..........
I've heard of people using a 3-jawed puller. The compressor is a ford FS10/Motorcraft YC-189. You'll need a tool to hold the clutch so it doesn't spin. A universal clutch holder tool (rent from local auto parts place or buy, about $20) will help. I'm about to replace the compressor on our 99 so if I get more details, I'll post.
Any air compressor that can achieve and hold 100psi will run an air gun. the larger the tank the more lugs you can remove before the compressor will need to run again.
1.75 lbs. of refrigerant
A four cylinder 2009 Ford Focus hold 4.5 quarts of oil.
Place rings into their respective positions on the piston. Place ring compressor over rings and tighten up until you can only just move the piston inside the compressor. Place the top of the piston into the bottom of the cylinder, push the piston and rings up out out of the compressor and into the cylinder keeping the compressor hard against the base of the cylinder. If you do not hold the compressor hard against cylinder the rings will slip out and you start again, you are not allowed to throw the compressor at your garage door until the third time. You should try it without a compressor, or have you?.
mine can hold 32gallons
The 1940 Ford car and truck has a gas tank that will hold 15 gallons of gas. The present day vehicles will hold more than the old Ford tanks.
35
how much tranmission fluid does my 93 tarsus hold.?
Mine hold 17 gallons.