The exact amount will depend on your gun patch and ball combination and distance you are shooting, and type of gun (pistol, smooth bore musket, rifle, carbine rifle, long rifle etc.) Each gun has it's "sweet spot" that is a powder charge and ball combination that gives consistent results, so you will have to experiment to find it. In my .50 flinter long rifle (42" barrel) I use 64 grains of 3F powder for shooting 50 to 100 yards and 50 grains under 50 yards, in my Hawken style flinter (28"barrel) I use 55 grains for long shots and 45 for short and in the pistol I use 25 grains. Those are target loads, for hunting I am between 75 and 90 grains on both guns, and the pistol is not used for hunting accept as a back up. The best way I have found is to start out with as many grains as the caliber and work from there placing targets at the distances you expect to be shooting. Fire 3 to 5 shots and record your results, increasing the powder charge by 5 grains each set. Keep in mind not to exceed the maximum recommended charge for your gun, and that the key to muzzle loading accuracy in consistency, load the exact same way each time, paying attention to the direction of the weave of your patch and how firmly you pack the load. With some time and patience you will have a tack driver.
When you fire flintlock, pouring gunpowder into barrel and powder pan is essential process. But in the show, musketeers just pull their flintlock out and shoot it without all these preparation. If they already poured gunpowder in their flintlock before battle started, gunpowder and the bullet must be poured out of barrel cuz when musketeers kept their flintlock in the belt, muzzle head towards to the ground. Is there any other way you can fire flintlock immediately during the battle? Or the show producer decided to ignore the fact that there's no way such thing can be possible?
Part of a flintlock muzzle loading gun. The pan is a shallow metal cup. It holds priming powder. When the trigger is pulled, sparks from the flint fall onto the priming powder, igniting it. This causes the main charge of powder to fire.
If it is a fire caused by petrol, use powder to extinguish it.
How would load your powder and ball down the barrel ram it down to make sure it's tight in the barrel then you would put powder in the pan when the flint hits the metal it creates a spark lighting the powder in the pan then lighting the powder in the barrel making it fire.
when weapons went from flintlock to percussion, chances of mis-fire due to wet powder ceased. with the flint lock the powder was exposed to some degree thus allowing it to get wet in rain and would not ignite..........
None of the above. A black powder gun uses a lead ball or conical bullet that is packed into the breech on top of the powder with a small piece of cloth wadding. These bullets are solid, and have no built-in primer like modern firearms. In a black powder firearm, the powder is in a small bowl on the top of the firearm. The spark from the spring-loaded flintlock strikes the frizzen, dropping a shower of sparks onto the gun powder.
powder or foam :)
The flintlock musket fires a (usually lead) projectile with a charge of black powder. When the shooter pulls the trigger, it releases a spring loaded flint striker. The flint striker ignites primer in the primer pan which then goes to ignite the black powder thus expelling the projectile. They are almost universally made to be muzzle loaders meaning that with every shot, the shooter had to pour black powder, a wad, and a lead bullet down the barrel, then prime and cock before being able to fire.
Baby powder+fire=more fire
Be removed from work immediately
They brought with them 15 regular flintlock rifles and one air gun that Lewis purchased in Pittsburgh which could fire 55 yards. They also took other necessary equipment, including powder horns, powder pouches, bullet molds, wipers, ball screws, repair tools, gun slings, flints, powder, and lead balls.
Fire extinguishers should be inspected annually - by a suitably qualified person.