The c6 is capable of handling 1300 hp , i have several in mud trucks and drag cars i`ve built in this hp range . It could possibly handle more( 2000hp ) but i havent been able to test on higher hp setups but this is something i plan on doing . The key is use the correct internal componets . I have been doing r&d on the c6 for several years and have found the " weak spots" , i also build or modify my own valve body and this is a big part of it holding up .I am a firm believer that the 3 spd will always be faster than a 2 speed because of the closer ratoi with 3 gear rather that 2 , you are able to run a higher diff ratio because of the lower 1st gear . WHITES TRANSMISSION sebring fl. 863-471-9775 home of the MEGA HP C6
about 300 hp and not more than 250 ft lbs of torque
No , just the automatic transmission has a torque converter
What is the Torque setting on transmission pan bolts 2002 ford ranger?
what is the torque on the bolts for the transmission pan on a 1991 ford thunderbird 3.8
The 1997 Ford Taurus torque converter solenoid can be found on the side of the transmission. The torque converter solenoid will be on the left hand side of the transmission.
The torque converter for an automatic transmission is inside the bellhousing area of the automatic transmission , the end of the transmission that is bolted to the engine
Pull the transmission and change it. The torque converter is inside the bell housing on the front of the transmission. Only way to get it out is to pull the transmission.
hand tight
Yes
4 quarts go in the torque converter and 3 in the pan.
it is a manual 5 speed tranny.
On your 2003 Ford Taurus : The torque converter is INSIDE the bell housing of your automatic transaxle ( transmission ) where the transaxle is bolted to the " rear " of the engine