0
How much should an apprentice charge to replace a light fixture. a side job?
Wiki User
∙ 14y ago
For a side job, $45 per hour since they is no insurance or contract signed and both parties are responsible for unknown consequences.
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
How do you replace the fog lights on a 1999 Grand AM?
there should be a bolt towards the top of the fixture and then you can either unclip the wire or pop out the bulb.
What should you charge to replace a starter?
Charge by the hour. Some models take more time.
You want to remove your vinyl shower stall replace with tile remove tile around the tub replace with new tile and retile the floor replace light fixture and paint what should the labor be?
twice the material
What Wattage should the UVB fixture be for a beardie?
The wattage of the UVB fixture for a beardie should be 26 watt bulb.
Have a bathroom light that is wired hot at all times how do you wire a pull chain up to it?
This sounds very strange. You should not have an unswitched bathroom light. Replace fixture with one with a pull chain. Turn breaker off before changing the fixture.
What should you do if you have had an iPod for a couple years and it does not hold the charge anymore?
Replace battery
How do you remove the tail light lens from a 1989 Chevy Celebrity?
The tail light lens on a 1989 Chevy Celebrity is part of the tail light fixture and cannot be conveniently removed. If you want to change a light bulb you have to remove the tail light fixture from the car. To remove the tail light fixture: 1. In the trunk next to the quarter panel are three nuts, remove the center nut. It should be in the center of the tail light fixture. 2. Pull the tail light fixture so that the stud comes out of the body, then pull outward to pull the tab out of the backup light fixture. 3. You can now take the appropriate socket out and replace the bulb. Reverse the steps to replace the light fixture.
How do you wire a fixture that had two hot and two neutral wires?
To install a new fixture to replace the one that was removed reconnect the two hot wires together and then reconnect the two neutral wires together. Place the two wires from the new fixture to the corresponding wire colours that you just spliced together. This wiring should be down stream from the light switch. When the switch is turned on the new fixture should light. If this is not the scenario of your question then more information needs to be given.
What should i charge to replace a hydraulic clutch?
Non-dealer $60 per hour
How often should an iPhone battery be replaced?
Replace it when it will no longer take or hold a charge.
How do you replace the dome light in 2004 Pontiac grand am SE?
On the clear cover press firmly on each side and the cover should come off. The bulb just sorta snaps in. Don't try to pry off the entire fixture or you will break off the holding studs and end up having to replace the entire dome light fixture...
What type of conductor should be used for wiring on fixture?
The conductors on and in the lighting fixture should have an insulation rating of 105 degrees C. The supply conductors to the junction box that the fixture is hung from or connected to should have an insulation rating of 90 degree C.
