0
How much should it cost to get a 1988 Oldsmobile cutlass ciera engine rebuild?
Wiki User
∙ 11y agoWant this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
What kind of oil should you use in your 1971 Oldsmobile Cutlass 350?
If the engine is original, use standard oil. If the engine is new or has had a full rebuild, using synthetic oil will result in a longer life for the engine.
How do you change fuel pump on 1988 Oldsmobile cutlass?
should be on the passanger front of engine, three screws. just pull.
What should the oil pressure be in 1987 Oldsmobile cutlass ciera?
General rule is that you need 10psi for every 1,000 rpm's of the engine.
Where is the fuel filter on a 1969 Oldsmobile cutlass?
Should be right in front of the carburetor, basically centre of the engine, steel pipe going into it.
Where is the cam sensor located on a 94 Oldsmobile ciera cutlass s?
The 1994 Oldsmobile Cutlass cam sensor is located on the back of the left cylinder head. The cam sensor should be labeled as such.
Where do you find the thermostat housing in the car for a 1984 Oldsmobile cutlass supreme?
follow the top radiator hose to the engine the hose is attached to it with a hose clamp, there should be two three bolts holding it to the engine
What should the water temperature be in a 1972 Oldsmobile Cutlass.?
Around 180 to 190 degrees fahrenheit.
Where is the speed sensor located on a 1996 Oldsmobile cutlass ciera?
It should Be located on the top of the transmission.
What is the cooling system fluid capacity for an 1987 Oldsmobile cutlass cierra?
The 1987 Oldsmobile Cutlass cooling system has a fluid capacity of 5.5 gallons. The cooling system fluid should consist of 50 percent antifreeze.
Should you rebuild your engine or buy a new engine?
balls?
How do you route a serpentine belt on Oldsmobile Cutlass Ciera?
There should be a diagram there. If not go to an autoparts store and they can find out for you.
Where is the cooling fan relay located in 1991 Oldsmobile cutlass ciera?
The 1991 Oldsmobile Cutlass cooling fan relay switch can be found attached to the right side of the radiator housing. The cooling fan relay switch should be labeled as such.
