0
How much should it cost to replace abs sensor on rear wheel of Chrysler town and country mini van?
Wiki User
∙ 6y agoWant this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
How much does it cost to replace a timing belt on a 2001 Chrysler town and country?
A town and country should have a chain.
Where is the oxygen sensor on a 2001 Chrysler Town and Country and is there more than one sensor?
its screwed into the exhaust pipe there should be 3 Two upstream and one after the cat
Cost of replacing a battery?
how much should a minivan battery cost to replace 2008 Chrysler Town and Country
How do you replace fan relay sensor on Chrysler neon 96 and where is it located?
The cooling fan relay sensor on 96-97 Chrysler neon should be located underneath vehicle, mounted to frame on drivers side front corner of engine compartment; (very forward inside wall of vehicle frame). Should be "unplug-unbolt" procedure.
How much should it cost to replace serpentine belt and tensioner on a 1998 Chrysler Town and Country?
I was told by a dealer $240 in January 2008.
Where is the oxygen sensor on a 96 Chrysler Town and Country?
Which one? These vans have 4 different O2 Sensors. You should go to the parts store to get a printout of the diagram.
2006 town and country touring Chrysler van i need to install an ambient air temperature sensor where is the sensor located on the vehicle?
Should be at the front of the vehicle, usually before the rad, some vehicles the sensor is mounted on the front bumper reinforcement.
What size engine is in the 2002 Chrysler Town and Country?
A 2002 Chrysler Town and Country should have a 3.8L V6 engine.
How much should it cost to replace a blown head gasket on a Chrysler sebring V6?
The price to replace a blown head gasket on a Chrysler Sebring V6 should be around $1,000.00. The price can vary depending on where you have the repairs made or if you replace it yourself.
When should you replace the timing belt on a 2003 Chrysler Sebring?
100,000 miles
Where are the transmission sensors located on a 1996 Chrysler Town and Country and how do you replace them?
It would help to know the engine size. but on the transmission look to the inside where the engine hooks to the motor. There should be a sensor that is actually looking back towards you. It is quite far under so you should take out your plenum and battery shelf. after the ribs to the left, you should be able to follow the wiring harness out of your fuse block.
How do you replace a serpentine belt on a 2002 Chrysler town and country?
There should be at least one (or more) idlers. You can pry against the spring tension to move it/them & slip the belt off.
