the clutch plate ,pressure plate and throwout bearing should cost around 110.00 labour will vary its about a 2 hour job for a garage or about 4 hours in your driveway
How do you replace a slave cylinder on a 1995 dodge neon clutch
I need to replace release bearing in a 1995 Chevy s10 truck and need to know how to disconnect the hydraulic clutch line for the transmission.
The 1995 Accord ghas a hydraulically operated clutch, notg a cable.
on tims HEAD
I need an answer to this too.
yes, some 1995 Chevy s-10 pick-ups did come with a manuel transmission. thus it uses a clutch (clutch plate, disc, throw out brg. and a pilot brg.)
Remove the transmission. Remove the clutch plate and springs. Remove the clutch. Reverse the process to install the new clutch.
You have to pull the tranny. Might as well put a new clutch disc and pressure plate while you re in there as well.
Is this a trick question??? If it's an automatic it won't have a clutch pedal lol!
== ==
the library should have a shop manual to make copies of for your vehicle...:)
About 2 and 1/2 hours.