Want this question answered?
remove the transmission......the proper term is a clutch release bearing
It requires removal of the transmission.
This is a big job requiring removal of the engine. The entire clutch should be replaced at the same time. It is not a job for the casual mechanic. --Ken
The clutch bearing or " throw out" bearing is going bad and will need to be replaced, take this opportunity to change the clutch as well.
It has a hydraulic operated throw out bearing.
remove the transmission and u will need a pilot bearing puller with a slide hammer which u can get at any auto-zone on loan.
yes it will run because the throw out bearing has nothing to do with the motor it's in the clutch.
A bad throw out bearing will make noise when the clutch pedal is pushed down.
Make sure clutch, pressure plate, and throw-out bearing are all in alignment
A throw out bearing is the bearing in a manual transmission that helps to engage and to disengage the clutch.
You must separate transmission from engine. Then the throw out bearing is located on a fork by where tranny attaches to engine. Remove bearing, pack grease into new one, install in reverse order of removing old bearing. You might as well change clutch and pressure plate. Install tranny to engine.
Ford release bearings ?throwout bearing and release bearing are the same thing. nothing to do with 4x4.Original post:RElease bearing? Possibly throw out bearing in transmission? Lock outs on a 4WD? Have not heard of release bearings.