yes you can, you will need to get a loom to convert the parrots iso connectors to the new style quadlock connectors, around £20
You have dirt in the sump which is being sucked up onto the filter and blocking the oil feed. When you turn off the engine, it drops back into the sump. Change the oil and filter. If big lumps drain from the sump, better to remove and clean out the sump. Then fit engine flush before new oil.
The 200-4R. The 700-R4 will fit but a new driveshaft would have to be fabricated due to the 700's longer tail.
One can find deals on a Peugeot 307 on websites that sell types of Peugeot as well as offline offsite automobile dealers which sell brand new Peugeot 307 and used Peugeot 307.
This is a common fault on the 307 and will require a new stalk switch module. Sorry : (
Not all new homes are built with a sump pump, but many communities that have had flooding problems now require them. You can install one yourself relatively easily if your home does not have one installed.
YES, the 5A heads FROM A 307 can be installed on a 403. The307 heads are a BETERR choice than the 67 to 72 Olds 350 heads. The 307 heads have similar sized intake & exhaust ports to the stock 403 heads. The 307 heads have a much smaller combustions chamber at arounf 67cc. This alone will raise compression to around 9.5:1. The only down side is the 307 heads have much smaller valves. You really must get larger valves installed into the 307 heads. The stock 403 valves will fit with some machining (of course) and you'll have a high compression 403. Get some port work done while you are at it & a little polishing too. Buy a new intake & have it machine & port matched to the intake & a middle of the road Lunati cam. This will result in a 403 producing around 330 HP. I know it works because this is exactly what I did. Enjoy your Olds, Mark
Average cost for a decent quality sump pump would hover around $1,600 installed Not sure where the 1600 number comes from. If you do an internet search, they can range from 100-300 dollars. Chances are, if you have one installed, it may run you between 200-300 dollars.
It's probably the top seal on the tank unit, especially if it does it when very full. Fit a new seal via the inspection plate under the back seat 1st. If problem persists after that a new tank will probably be required.
form_title=Sump Pump Installation form_header=11503 What is it you need a sump pump for?*= () Water leaks through walls () Basement floods during storms () Basement floods due to rising water table () In case pipe bursts or basement drain is clogged () Other () Don't Know Does the new pump location have electricity close-by?*= () Yes () No () Don't Know
Apparently £375 or so we have been quoted by peugeot in New Malden
522