To fix a clogged brake line, first find the clog. Then, remove the clogged line from the cylinder. Attach a new line, and pump the car's brake to test it before driving.
your virginity
To fix a rear driver's side brake line on a 1994 GMC Sierra 4x4 at a shop can run as high as $300. The parts can be purchased to repair the brake line for under $50.
it depends if it is a metal line or rubber lines , if it is at a fitting or at the master cylinder or abs i can help you find these if you cant locate the leak
Replace the brake line, bleed the brake. top up with brake fluid. Done.
You have to change the line, too much pressure to do anything else.
Rebuild the cylinders on that caliper.
depends where the leak is. In the brake line or at the pump? electric or mech brakes? if its in the line you should be able to replace the line section
Begin by removing the brake lines. Remove the master cylinder retaining bolts. The master cylinder will come off. Reverse the process to install a new master cylinder.
For your own safety replace, do not repair
Yes. You can fix the mistake of putting engine oil in the brake fluid. It is the easiest if you just caught it as soon as you did it. In that case you disconnect the master cylinder as quick as possible from the brake lines. You do not want oil to clog the brake lines. Then you remove as much brake fluid, oil mix from the master cylinder as possible. Then you take a rag and clean out the master cylinder. Then you run brake fluid through the master cylinder until it comes clean. Then you run brake fluid through the brake lines to make sure they are clean. If brake fluid does not go through the brake lines, you did not catch it in time. You need to replace your brake lines and slave cylinders. You have just learned an expensive lesson.
replace brake line