about 60cm3~
A boiling tube typically holds around 5-20 milliliters of liquid, depending on its size and design.
Assuming the tube is a circular pipe, the volume of water it can hold per meter can be calculated using the formula for the volume of a cylinder: V = πr^2h, where r is the radius of the tube (half of the diameter, so 20 mm or 0.02 m) and h is the length of the tube (1 m). Plugging in these values, the tube can hold approximately 0.025 liters or 25 milliliters of water per meter.
Most bicycle inner tubes can hold pressure in the range of 40-120 psi (pounds per square inch), depending on the manufacturer's specifications and the tire size. It is important to check the recommended pressure range printed on the tire sidewall to prevent damage to the tube or tire.
A test tube with a side arm, also known as a boiling flask, resembles a boiling tube with a hole. The side arm allows for the release of pressure or the addition of other materials during heating processes, making it suitable for distillation or reflux reactions.
A beaker or test tube is commonly used to hold liquid substances in science laboratories. These containers are designed to safely contain and measure the volume of various solutions or substances during experiments.
To calculate the mass of a hollow tube, you need to know the outer diameter, inner diameter, and length of the tube. First, calculate the volume of the tube by subtracting the volume of the inner hole from the volume of the outer cylinder. Then, multiply the volume by the density of the material to determine the mass.
Test tube racks are typically made of metal, plastic, or wood to hold test tubes in place and keep them organized during experiments or storage. They come in various sizes and configurations to accommodate different numbers and sizes of test tubes. The material used depends on the desired durability, chemical resistance, and safety requirements of the laboratory setting.
A retort stand is to hold a test tube/ boiling tube. 1. Turn the side knob( by the "t" on the retort stand) and release it. 2. Put the test tube/boiling tube in the test tube/boiling tube holder. 3. TIGHTEN the side knob ( if not the test tube/ boiling tube will drop). 4. Adjust the height of the retort stand by turining the most corner knob. (if you need to)
a test tube is the answer
Most bicycle inner tubes can hold pressure in the range of 40-120 psi (pounds per square inch), depending on the manufacturer's specifications and the tire size. It is important to check the recommended pressure range printed on the tire sidewall to prevent damage to the tube or tire.
looking for length of tube if i.d is 93mm and is to hold 1ltr of fluid
A boiling tube is used for boiling a liquid in
The boiling tube store
Test tube racks are commonplace in school science labs and are used routinely to securely hold test tubes or boiling tubes that are being observed or filled.
A graduated cylinder is a type of test tube that measures volume with markings along its side.
A boiling tube is for boiling chemicals or metals, a test-tube is for holding chemical reactants. Test tubes are slimmer, boiling tubes are wide and are made of thin glass
sex
75.4 cubic inches.