0
How much will it cost to replace the AC compressor in a 1996 Mazda mx-6 or what is the most expensive thing to replace with the AC system?
Wiki User
∙ 14y agoWant this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
Where is the low pressure port for the ac system for a 1998 Mazda 626?
The 1998 Mazda 626 low pressure port for your air conditioning system will be on the top of the air conditioner compressor. The low pressure port will be on the left-hand side of the compressor.
Ac compressor 89 Mazda rx7?
Nippon-Denso
How do you replace the AC compressor on a '93 Mazda 626 with a six cylinder?
the library has chilton repair manuals,i just copy the page,pages that i need for .10 cents a copy
How do you replace a Body Control Module in a 2006 Mazda 6?
Good question! I took mine to the dealership since it is under warranty still. If not, it would be expensive and difficult to replace on your own.
What is the purpose of the high side pressure switch on the air conditioning system in a Mazda 1993 2600i pick-up truck?
To shut down the compressor so the system doesn't blow up.
Should I replace Mazda engine or buy new car?
Replace the Mazda engine.
How to replace a starter on a 2001 Mazda Tribute?
How to replace a starter on a 2001 Mazda Tribute?
How do you replace the thermostat located on a Mazda truck?
how do replace the thermostat on a 1999 mazda b2500 truck?
What is the cost to replace the head gasket on a Mazda MPV?
What is the cost to replace the head gasket on a Mazda MPV?
How do you replace headlight bulb on 2004 Mazda Tribute?
How do you replace headlight bulb on 2004 Mazda Tribute?
How do you replace a fuel injector on a 2001 Mazda mpv?
How do you replace a fuel injector on a 2001 Mazda mp
How do you replace the serpentine belt for a 1993 Mazda Protege?
you have to loosen a bolt on the front of the AC compressor, I think its a 12mm. You loosen it and the the AC compressor will then be able to rotate downward, sometimes the compressor gets stuck with age and you might need to tap it down with a mallet. Once the compressor rotates downward the tension in the belt will be gone and you can change the belt. Then tighten the same bolt until you achieve the desired tension
