That completely depends on the voltage of the battery.
The energy delivered by the battery and dissipated by the resistor in one minute will be
[ 60 x (Voltage of the battery)2 / 21 ] joules
The main difference is that lighting caps are required to contain a bleed resistor in parallel across the cap s terminals to drain the high voltage contained in the capacitor to safe levels (usually within a minute or so) after the equipment is switched off. Motor run caps don't require bleed resistors due to them being constantly connected to the motor windings which act like a resistor to drain the capacitor after use.
The best way to fix uncaught exception java lang Null Pointer Exception on a Blackberry 8300 is by doing a restart. Shut the phone off and remove the battery for a minute. Replace the battery and turn the phone back on.
350,000 every minute.
About 1.25 gallons per minute.
Answer The easiest way is to connect it directly to the battery. Make sure the polarity matches up. (-ve to -ve, and +ve to +ve). Because it is 1F, it will take some time to charge. (probably a minute or two.) In that way, the capacitor will charge to whatever the voltage of the battery. But won't be fully charged,
Good chances are, the alternator is not connected correctly or is defective.
Disconnect the negative battery cable for about a minute Disconnect the negative battery cable for a minute or so
Disconnect the battery for a minute.
Once the smoke escapes you cannot put it back! Seriously, though, Make sure that the Ground is connected to the chassis/solid grounding point and not the battery, make sure the donor car runs for a minute or two while connected before attempting to start the dead car. Also helps to increase the RPM of the donor car while cranking the other.
1 minute
not if you replace the battery fairly quickly, it has built in capacitor which keeps its ower for a minute or so.
Nothing will happen if you dip the free ends of the wire in a glass of distilled water with a 9 volt of battery for a minute.
Disconnect battery once again then touch both battery cables together for about a minute. Reconnect battery and allow time for the comp to relearn environment
I think Lead acid battery 650 Va is best for UPS because it is economical and battery backup is upto 45 minute for lcd monitor and 20 minute for CRT monitors. but you can increase the back time by increasing power of these battery . Age of battery about 2-3 year and price will about 500 INR for 650 VA or 12 USD or 7 GBP approx.
Current is measured in C.s-1 thus the amount of coulomb per second therefore in one minute there is: (60s x 4C.s-1) = 240Coulomb charger past any point in the resistor(or circuit). There is 6.241 509 629 152 65 × 1018 electrons in one coulomb charge (see why we use coulomb in stead of electrons!) thus there will pass 6.241 509 629 152 65 × 1018 X 240 electrons through the resistor in one minute if one amp current is present, i.e. = 149 762 310 960 000 000 000 or 1.49x1020
About 3 minutes each percent
Unhook the battery for a minute to reset the PCM.