Want this question answered?
the self control of a synchronous motor is done using an inverter fed through a dc link.speed is controlled by varying the output frequency of the inverter by controlling the dc link voltage
A PLL is different than a VCO. Each has its own use. Actually a PLL (Phase Locked Loop) contains a VCO (Voltage controlled oscillator). A VCO is an oscillator whose frequency is related to an input voltage. You can use it when you need a varying frequency that is controlled by a varying voltage. But it is not great at outputting a consistant exact voltage because it is very sensitive to its environment (e.g. temperature). A PLL will "lock" its output frequency to some input frequency. So it can oscillate at a frequency that is controlled by an input oscillator. Not too useful if the output frequency is the same as the input. But the output frequency can be divided before it is compared to the input. This allows the output frequency to be higher (some multiple of) the input frequency. Once a PLL is "locked on" to an input frequency it can be very stable.
In industrial, there is a device called variable frequency drive (allso frequency inverter, ac drive) to control the motor speed by adjusting output frequency.
Fully controlled rectifier uses only SCR's Negative output voltages are obtained two quadrant control wide range control costly semi converter uses diodes and SCR's only positive output voltages are obtained one quadrant control only positive half cycles are controlled
twice the input frequency
what is Output Controlled Grant-based Round Robin ?.what for it is used ?.
Audio output frequency is that range of frequencies that can be heard. For humans, that is generally considered to be the range of 20Hz to 20kHz.
In natural frequencies the output of the system will be less than the maximum level. In the resonance frequency the output of the system will be the maximum level.
answer for me please
Every i/o device is controlled by software. Every new device that is installed you must install its device drivers to control the device.
There are several methods for generating FM signals but they all basically involve an oscillator with an electrically adjustable frequency. This type of oscillator uses an input voltage to affect the frequency of its output. For example, when the applied voltage increases, the oscillator output frequency increases and when the applied voltage decreases, the oscillator output frequency decreases as well. If no voltage is applied to the oscillator its output will be a signal at its centre frequency. The amount of frequency variations is deviated around the oscillators' centre frequency.
3MHz