0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
How do you take the axle out of a Chrysler 8.25?
To remove the axle shaft, first remove the wheel, and brake drum/rotor. Second, remove the differental cover. Third, remove the bolt holding the spider gear shaft, and remove that shaft. Fourth push inward on the axle shaft to remove the horseshoe clip on the inside. The axle shaft will now pull out.
How do you remove rear axle 2003 gmc Yukon?
Remove wheel, Remove drum or disc brake rotor,remove rear differental cover. Remove shaft between the spider gears that is held in by a lock bolt. Shove the axle from the outside toward the differential and remove the "C" clips that hold the axle in inside the diff. and then the axle can be removed.
How do you remove axle shaft onb daewoo cielo?
how do i remove the axel shaft off the daewoo cielo
Is there inner c clips that hold in the rear end axle on a 2003 jeep grand Cherokee?
No, you remove the 4 nuts on the outside, and pull the axle shaft out with a slide hammer.
Is there a clip on a 1999 grand Cherokee rear axle?
No, the rear axle shaft does not have an internal retainer clip. You remove the four nuts on the inside of the brake backing plate and remove the axle shaft with a slide hammer and hub adapter.
How do you remove a Honda xr250 front wheel?
Lift bike up off of ground. Remove front brake pads. Remove speedometer gear box screw and pull out cable. Loosen 4 small bolts on axle shaft holder. Loosen axle shaft. Remove axle shaft, 4 small bolts and holder. Wheel will come off.
Can you remove a transmission on a 2001 Eclipse without removing the right Transaxle?
The car has only one transaxle, AKA transmission, then no, you cannot remove the tranny without removing the tranny. If you mean without removing CV Axle or drive axle or Axle shaft or CV shaft (same thing) then the answer is still no. You cannot remove the transaxle without removing the drive axle/CV shaft.
How do you remove rear axle from 99 4wd suburban?
remove diff cover, turn carrier till you see bolt that holds cross shaft in place, unscrew cross shaft bolt but don`t remove, slide bolt out untill shaft can be carefully slid out again not completely keep shaft in side gear but out enough to clear axle. from brake area push bad axle in untill c-clip is released. remove clip and retain, slide axle out of diff push shaft back in and push bolt back thru shaft to hold in place.
How do you remove the hub and rotor assembly to take out the jack shaft on a 2003 dodge ram 2500 4x4?
a jack shaft is the small drive shaft from transfer case to front differential, brakes have nuthing to do with removal of a jack shaft maybe you mean removal of front axle
Rear axel removal on 1998 Ford Expedition?
how do you remove the right rear axle on a 1998 ford expedition?
How do you remove the right front axle shaft out of the differential on a 1992 ford F150 4x4 with a 5.8L?
How to remove the right side axle half on a 1995 f150
How do you replace wheel bearing assembly on 98 Malibu?
After you remove the wheel, remove the caliper and caliper mounting bracket. There is a nut on the end of the axle shaft. Remove the nut. There are three bolts on the back of the steering knuckle that hold on the wheel bearing. Remove these bolts. Then with a punch or chisel and hammer, strike the axle shaft until the old bearing comes out. Reverse procedure to install. Don nut re-use the axle shaft nut. Do not under- or over-tighten the axle shaft nut. Torque for the nut is 180 ft lbs.
