Turn key II position
Press & hold Odomenter reset button until service light flashing.
Press the reset button again for > 5 seconds
The service oil life display will be reset to 100%
I have a 2006 Pilot and I reset the oil life meter by holding in the dash button (the one used to toggle between the odometer, outside temp, oil life, etc) for 30 seconds. It starts to flash at about 20 seconds and will reset at 30 seconds.
Turn key II position Press & hold Odomenter reset button until service light flashing. Press the reset button again for > 5 seconds The service oil life display will be reset to 100%
Using the odometer post (little thingee sticking out of the speedometer) push the post until the oil life is displayed. Then push and hold the post for about 10 seconds. This should reset the oil life to 100%
select oil life on the MID then press and hold reset for 10 seconds and oil life will reset to 100%. this is in owner's manual.
Mayor for Life - 2010 Pilot 1-1 was released on: USA: 2011
H-O-P-E - 2011 Life Alone Pilot 1-1 was released on: USA: 10 September 2012 (Phoenix, Arizona)
With the ignition key off, press and hold the odometer reset button, and turn the ignition on and do not start the car. In about 2 seconds the light will reset.
Turn the ignition switch to the ON (II) position Press the Select/Reset knob repeatedly until the engine oil life is displayed. Press the Select/Reset knob for about 10 seconds, The engine oil life and the maintenance item code(s) will blink. Press the Select/Reset knob for another 5 seconds. The maintenance item code(s) will disappear, and the engine oil life will reset to "100".
Turn ignition on,need not running.Hold the reset button in until oil life xxx% blinking ,let go the button.Then hold it in again until it shows oil life 100%.
Cycle to where you view the percentage of oil life. Hold the odometer reset peg for about 15 seconds until you see it flash or beep (not sure which one), then let go and push it once again. The second push should reset your maintenance light and oil life indicator.
With the ignition key off push and hold the odometer reset button and then turn on the ignition switch without starting the engine. After 5 seconds the maintenance required light will go off and reset.
Try holding in the trip mileage reset button while turning the key to the run position. Continue pressing the button for 10 seconds or so. The light should go off. == The manual for my 2008 Pilot says: - Turn ignition switch to ON (II) - Press select/reset knob until engine oil life is displayed. - Press select/reset knob for about 10 seconds until the display starts blinking. - Press select/reset knob for another 5 seconds, the display will reset.