Hello, it can get to be a serious problem! if you are not hearing noise while turning yet? it would be a perfect time to replace the boot! as you might be at the right time to still save the bearings inside the shaft!!
good luck and be safe!!
on the back of the fuse box cover
.008 under normal operating conditions.
just bring the car to the trusted mechanic....
On a 1997 Toyota Tercel, the cabin air filter is located behind the glove compartment. To access it, you need to remove the glove compartment door by detaching the stops and screws. Once the glove compartment is out of the way, you can find the filter cover, which can be removed to replace the filter.
Toyota tercel,canry timing markif it have a 2.0 engine sfe the timing mark is on the crankshaft balancer,which must be line up with the timing belt cover,timing mark.also the camshaft pulley there is a mark on it,that must be line up with with the mark on the back boardof the pulley.now you got it.most Toyota time the same way.
I have a '95 Tercel and the OBDII port is located inside the fuse box cover on the lower left side of the dash to the left of the steering wheel. If you go to a parts store they will tell you it doesn't exist, so just open the cover and show them. It is in fact there.
In a 1991 Toyota Tercel, the AC fuse is located in the fuse box, which is typically found under the dashboard on the driver's side. You may need to remove a cover to access the fuses. Look for a fuse labeled "AC" or "Air Conditioning" in the diagram on the fuse box cover to identify the correct fuse. If you're having trouble, refer to the owner's manual for specific details.
To change the air filter in a 1989 Toyota Tercel, first, locate the air filter housing, which is typically a black plastic box near the engine. Unscrew or unclip the housing cover to access the air filter. Remove the old filter, noting its orientation, then insert the new filter in the same direction. Finally, reattach the housing cover securely to complete the process.
To change the rear speakers in a 1994 Toyota Tercel, start by removing the rear speaker grille or cover by gently prying it off with a flathead screwdriver. Once the cover is off, unscrew the existing speakers and disconnect the wiring harness. Replace the old speakers with the new ones, reconnect the wiring, and secure them with screws. Finally, reattach the speaker grille to complete the installation.
There is a little wedge at the bottom, stick a nail fail there and pop it out. Then you just have to pull the cover down to reveal the speakers
The PVC (positive crankcase ventilation) valve on a 1996 Toyota Tercel is located on the engine's valve cover. It is typically positioned near the rear of the engine and is connected to a rubber hose that routes to the intake manifold. To access it, you may need to remove any obstructing components, such as the air intake duct.
Find the screws for the center cover area and remove them. I think there's 6 screws. Once you get the center cover removed, the radio has two more screws. The rest should be easy.