0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
What makes a slide faster to slide down?
for a water slide pull down your swimsuit by your but. Furniture polish on the slide, sitting on a mat or lycra trousers.
How do you pull down the top bar on a Samsung Intercept?
You should be able to just put your finger on it.Then just slide your finger down the screen.
What would happen if you slide down a slide with water on it?
youd go faster, but the slide would get sticky after a while and would give someone a wedgie or pull their pants down!
Why does hold your horses mean to be patient and wait?
Holding your horses means you pull up on the reins and slow them down -- it means for you to slow down and be patient.
Need instructions on disassembling a Glock 40 for cleaning?
Its easy to do, pull back the slide a tiny bit, then pull down the tabs on the side, the slide will then slide off. Take out recoil spring and barrel clean them, lube everything but not too much.
How do you make yourself not pissed at yourself?
Take My Advice, Pull Down Your Pants And Slide On The Ice!
How take apart bryco 380?
Place the pistol on safe. Remove magazine, pull back slide and be SURE weapon is unloaded. Push the take-down button located at the rear of the slide using a punch tool. While holding the take-down button in, lift the slide away from the frame, then release the take-down button and pull the slide off the front of the gun. The firing pin and spring can be removed from it's slot in the slide. I strongly advise to go no further.
How do you take apart sw9ve?
The SW9VE is super easy to take apart. First off, make sure its UNLOADED. One quirk of this gun is that you have to pull the trigger to disassemble it. After you're sure its unloaded, you can go to the next step. You should see a little pull down lever right above the trigger that goes all the way through the frame. Pull the slide back then pull down on both sides of the lever and let the slide go back forward. It may not look like anything happened, but it should be released at this point. Now pull the trigger (like I said - UNLOADED is important). The slide should move forward a little bit and you can take it the rest of the way off by hand. If it doesnt come off, you probaby didnt get it released all the way. Pull the slide back and try again. The barrel and spring assembly will drop right out and you're done with disassembly. To put it back together, put the barrell and sping assembly back in the slide, line up the grooves on the frame and slide and push the slide back. It will click into place and you're ready to shoot.
How do you insert a nasal canula?
Assuming you're doing this for someone else:1) pull the plastic slide down so that the cannula will definitely be large enough to fit the patient2) hold the cannula with both hands so that the prongs are facing away from you and curving down3) put the prongs into the patient's nostrils4) pull the tubes over and behind both of the patient's ears at the same time5) adjust the plastic slide back up so that the cannula isn't tight enough to bother the patient yet the cannula won't slide off.
How do you break down a lorcin 380 hand gun?
clear gun , pull slide back and push in takedown trigger wich is located around firing pin and pull slide up crarfull things tend to jump out
How do you remove manual tranny 1987 Toyota truck?
pull out the tranny about 3inches then tilt it to the right and pull it past the bellhousing then tilt the trannny down and slide it out
What should you do if you took the barrel and recoil spring out of my Glock 17 and put the slide back on?
never mind i got it....i had to pull the slide forward and when the trigger went into firing position you pull the trigger while continuing to pull forward...i was scared as hell for a minute
