0
What else can I help you with?
What is the unit of density for liquid?
Density unit is mass / volume. SI unit for dendity is kg/m3.
What is the customary unit for liquid volume of a sink?
Gallon
What is the rate of condensation formula used to calculate the amount of water vapor that changes into liquid per unit time?
The rate of condensation formula is used to calculate the amount of water vapor that changes into liquid per unit time. It is typically expressed as the mass of water vapor condensed per unit time.
What unit is used to label liquid volume?
The unit or label to measure liquid volume is ml (milliliters)
The is the slant of a line on a coordinated graph?
The slope is the slant of a line
What is the liquid line and suction line?
The suction line is the big one. This line should be cold when the unit is on. The small line is the liquid line.
Should the liquid line of an ac unit be cool?
No, the "liquid line" is the little line, also called the "high side" line. When operating properly, it should be hot, sometimes very hot.
How far should oil-trap has to be from 20 ton ac unit?
Half way between the the condenser and air handler, in the liquid line.
What two copper lines connect the evaporator section with the condensing unit?
suction line liquid line
At microwave frequency why should the transmission line may considered to be made of unit length?
at microwave frequency why should the transmission line may considered to be made of unit length?
What unit would you use to measure a the liquid in a dropper?
millileter (ml) should be appropriate for that.
What is the correct procedure for a pump down?
With the unit running, front seat the liquid line valve and monitor the pressure. Once you have the unit in a vacuum, front seat the suction side and cut the power to the unit.
What is the SI unit of liquid volume?
Milliliters is the SI unit of a liquid volume
What unit is the volume of a liquid measured in?
litrer is the unit for liquid in metric system. and cubic meter in SI unit.
How do you remove a clog without losing all freon from the thin copper tube on the low pressure side of a split AC that is frozen for 10 inches then a couple of fittings and it is warm from there on?
There should be a pump down valve at the condenser. One for the suction and one for the liquid side. Simply front seat the valve on the liquid line and wait for the unit to pump down, then front seat the suction side and cut the pipe and replace. You may want to install a liquid line dryer before you evacuate the system and recharge the unit.
What large line unit connects the indoor unit to the out door unit?
Discharge line
What unit for volume would you use for a liquid?
the unit for volume, for a liquid would be oz(ounces) I believe..
