answersLogoWhite

0

No, the "liquid line" is the little line, also called the "high side" line. When operating properly, it should be hot, sometimes very hot.

User Avatar

Wiki User

14y ago

What else can I help you with?

Related Questions

What is the liquid line and suction line?

The suction line is the big one. This line should be cold when the unit is on. The small line is the liquid line.


How should the liquid line of an ac unit feel?

The liquid line of an AC unit should feel warm to the touch. If it feels hot, it may indicate an issue with the system such as a restriction in the line or an overcharged system. If it feels cold, it may suggest a lack of refrigerant or a problem with the compressor.


How far should oil-trap has to be from 20 ton ac unit?

Half way between the the condenser and air handler, in the liquid line.


What two copper lines connect the evaporator section with the condensing unit?

suction line liquid line


At microwave frequency why should the transmission line may considered to be made of unit length?

at microwave frequency why should the transmission line may considered to be made of unit length?


How long should it take for a 5000 btu unit to cool a room?

500sq.ft


Should the outside unit ac fan be blowing cool?

No the out side fan is for venting heat away fromt he unit.


What unit would you use to measure a the liquid in a dropper?

millileter (ml) should be appropriate for that.


What is the correct procedure for a pump down?

With the unit running, front seat the liquid line valve and monitor the pressure. Once you have the unit in a vacuum, front seat the suction side and cut the power to the unit.


What is the SI unit of liquid volume?

Milliliters is the SI unit of a liquid volume


What unit is the volume of a liquid measured in?

litrer is the unit for liquid in metric system. and cubic meter in SI unit.


How do you remove a clog without losing all freon from the thin copper tube on the low pressure side of a split AC that is frozen for 10 inches then a couple of fittings and it is warm from there on?

There should be a pump down valve at the condenser. One for the suction and one for the liquid side. Simply front seat the valve on the liquid line and wait for the unit to pump down, then front seat the suction side and cut the pipe and replace. You may want to install a liquid line dryer before you evacuate the system and recharge the unit.