What temperature should liquid line be on 134a refrigerant
Density unit is mass / volume. SI unit for dendity is kg/m3.
Gallon
The rate of condensation formula is used to calculate the amount of water vapor that changes into liquid per unit time. It is typically expressed as the mass of water vapor condensed per unit time.
The unit or label to measure liquid volume is ml (milliliters)
The estimate would be just under 8 gallons. Pounds is a unit of mass/weight. Gallons is a liquid measure. They do not convert cleanly. The density of the liquid being measured can make a big difference. If the liquid is water, there is 8 pounds to a gallon.
The suction line is the big one. This line should be cold when the unit is on. The small line is the liquid line.
No, the "liquid line" is the little line, also called the "high side" line. When operating properly, it should be hot, sometimes very hot.
Half way between the the condenser and air handler, in the liquid line.
suction line liquid line
at microwave frequency why should the transmission line may considered to be made of unit length?
millileter (ml) should be appropriate for that.
With the unit running, front seat the liquid line valve and monitor the pressure. Once you have the unit in a vacuum, front seat the suction side and cut the power to the unit.
Milliliters is the SI unit of a liquid volume
There should be a pump down valve at the condenser. One for the suction and one for the liquid side. Simply front seat the valve on the liquid line and wait for the unit to pump down, then front seat the suction side and cut the pipe and replace. You may want to install a liquid line dryer before you evacuate the system and recharge the unit.
litrer is the unit for liquid in metric system. and cubic meter in SI unit.
Discharge line
the unit for volume, for a liquid would be oz(ounces) I believe..