0
The slip vary with load is a AC electric motor which the electric current in the rotor needed to make torque that is induced by electromagnetic induction. It does not repair mechanical commutation parts the energy and transferred from stator to rotor.
Wiki User
∙ 10y ago
Add your answer:
Earn +20 pts
What is meant by slip-sheet load?
The load is composed of silk sheets
Load test on 3 phase induction motor?
When you do a load test on a 3-phase induction motor you are checking the power factor, viz slip, and efficiency of the motor. You can test various loads with this test.
Why is motor current draw lower at full speed?
Because full speed is unloaded. As you load the motor, speed decreases, and slip increases, with an accompanying increase in current.
What is on load tap chenger?
A tap changer is used to vary the turns ration between the windings of a transformer to make minor changes to the secondary voltage. An on-load tap changer enables the turns ratio to be altered without disconnecting the transformer. An off-load tap changer requires the transformer to be temporarily diconnected. On-load tap changers are installed on the high-voltage side of the transformer, where the current is lower.
What is full load current of 20 HP induction motor in delta?
480V about 20A 240V about 40A look at the nameplate duty cycle and efficiencies vary
What is meant by slip sheets?
The load is composed of silk sheets
What is meant by a slip- sheet load?
The load is composed of silk sheets
What is meant by slip sheet load?
The load is composed of silk sheets
What is meant by slip-sheet load?
The load is composed of silk sheets
What is meant by a slipsheet load?
The load is composed of silk sheets
What is the schmid factor?
The Schmid factor m is part of the equation for the critical resolved shear stress τ0. The critical resolved shear stress is the component of shear stress in a slip plane, resolved in the direction of slip, necessary to initiate slip in a grain (plastic deformation in metals). m = cos(κ)cos(λ) ; τ0 = mσ κ - the angle between the applied load direction and the slip plane normal. λ - the angle between the applied load direction and the slip direction. σ - the applied stress or load
What is pole slip in generator?
the link: http://www.av8n.com/physics/power-grid.htm defines pole slip as: " if the load mismatch becomes extreme, one generator could slip 2pi of phase relative to the other. In the industry this is called pole slip".
How will the speed and the slip of the motor change with increasing load in star wye and delta connection?
the speed decrease if increasing load..in star connection the speed lower
Why the chain does not slip from the pulleys when the load is being lifted?
The front part of a ship is called the stem. It is connected to the keelson and keel.
Why the chain does not slip from the pulleys when load is being lifted?
The front part of a ship is called the stem. It is connected to the keelson and keel.
Why does material weight normally vary from weighbridge to weighbridge?
Material weight can vary between weighbridges due to factors such as calibration differences, wear and tear on the equipment, environmental conditions, and variations in measurement techniques. It is important to ensure weighbridge accuracy and calibration to obtain consistent measurements.
Load test on 3 phase induction motor?
When you do a load test on a 3-phase induction motor you are checking the power factor, viz slip, and efficiency of the motor. You can test various loads with this test.
