0
It does not depend on the line. The regulation is the percentage change in voltage caused by applying the full load current, and that depends on the transformer supplying the line. A value of 5% would be typical.
Wiki User
∙ 9y ago
Add your answer:
Earn +20 pts
What is Indian railway transmission line voltage?
220v, 415v, 6.6 kv, 11kv,33kv,132kv,400kv
What is low voltage ic 723 regulator?
ic voltage regulator is good for line or load regulation
Why is voltage regulation of dc line is better than ac line?
in dc circiuts only resistors are responsible for voltage drop. where as in ac circuits inductances and capacitances are also responsible for voltage drop in addition to that of ressistors
What is regulation of a transmission line?
Regulation has to do with keeping the voltage at a desired value. This is often put in a per unit value, which you can think of as a percent of nominal. So if the desired voltage is 34.5kV, and the actual voltage is 33.8kV, the voltage is .98 per unit. There are regional and national rules on how low or high voltage can be. If the voltage strayes from this, it must be regulated back to an acceptable value.
When transformer voltage regulation will be zero it operate at?
A transformer will operate with a voltage regulation of zero when it is not supplying a load.
How do you calculate voltage regulation of 33kv and 11kv distributions?
Regulation =(Obtained voltage per phase - rated voltage per phase)/rated voltage per phase *100
What are the effects of being at end of 33KV transmission line?
The effects of being at the end of a 33KV transmission line will result in a higher voltage. This is due to variation in the perameters that dictate how the transmission is sent and received.
What is line regulation?
Line regulation is a measure of the ability of the power supply to maintain its output voltage given changes in the input line voltage. Line regulation is expressed as percent of change in the output voltage relative to the change in the input line voltage.
What is Indian railway transmission line voltage?
220v, 415v, 6.6 kv, 11kv,33kv,132kv,400kv
Line regulation and load regulation of zener diode?
Line regulation defines as the output voltage of the zener to remain constant under input line variation. Load regulations defined as the load increases or decreases the zener will control this variation by keeping the voltage constant.
Define voltage regulation and efficiency of a short transmission line?
Voltage Regulationvoltage regulation of a line is defined as the change in voltage at the receiving end when full load at a given power factor is removed, the voltage at the sending end being kept constant. it is expressed as a fraction or a percentage of the receiving end voltage at full load. it can be written as, Per unit regulation = Vrnl - Vrfl / VrflPercent regulation = (Vrnl -Vrfl / Vrfl) * 100Efficiency of a Short Transmission LineIt is the ratio of the Power Output of the line to the Power Input of the line.
What is line in line regulation?
Line refers to the a.c. supply line. Line regulation is the change in output of a device, usually a power supply, which is due to variations in the voltage of the a.c. supply.
What is low voltage ic 723 regulator?
ic voltage regulator is good for line or load regulation
Why transmission line voltage is like 6.6kv 11kv22kv 33kv etc?
Usage of such high voltages will increase the efficiency of the transmission lines and decreases the losses in the line. It also reduces the requirement of conductor size.
Explain the transmission and distribution of electricity from the generation station to the consumer?
transmission and distribution of electricity are the way of regulate voltage to the minimum rate in which can be benefit to the consumers. From generating station , voltage generated is up 16/25kv which step up upto 330kv this generating voltage now step down in the transmission station through the step down transformer which is 132kv this voltage now transmitting to distribution station where voltage now step down to 33kv, this 33kv now stepdown to 415v for three line and 240/220v for a line for the uses of consumers.
What is the line voltage given the load voltage is 2000v and voltage regulation is 2 percent?
The line voltage in the usa is 120V if the 2000V is for a tube in a microwave oven it generally depends on a transformer and rectifier so the line voltage will go down about 2% to retain the output
Is percent voltage regulation can be negative?
yes.. voltage regulation can be negative
