Regulation has to do with keeping the voltage at a desired value. This is often put in a per unit value, which you can think of as a percent of nominal. So if the desired voltage is 34.5kV, and the actual voltage is 33.8kV, the voltage is .98 per unit. There are regional and national rules on how low or high voltage can be. If the voltage strayes from this, it must be regulated back to an acceptable value.
It does not depend on the line. The regulation is the percentage change in voltage caused by applying the full load current, and that depends on the transformer supplying the line. A value of 5% would be typical.
No, but transmission line act as a lpf
Pole and transmission line hardware is purchased by cable television and utility companies
Image result for Why phases in transmission line are transposed?Transposition is the periodic swapping of positions of the conductors of a transmission line, in order to reduce crosstalk and otherwise improve transmission. ... Transposition also equalizes their impedance relative to the ground, thus avoiding one-sided loads in three-phase electric power systems.
ic voltage regulator is good for line or load regulation
Voltage Regulationvoltage regulation of a line is defined as the change in voltage at the receiving end when full load at a given power factor is removed, the voltage at the sending end being kept constant. it is expressed as a fraction or a percentage of the receiving end voltage at full load. it can be written as, Per unit regulation = Vrnl - Vrfl / VrflPercent regulation = (Vrnl -Vrfl / Vrfl) * 100Efficiency of a Short Transmission LineIt is the ratio of the Power Output of the line to the Power Input of the line.
Voltage regulation is just the percentage change in voltage at the receiving/sending end of the transmission line from no load to full load. It is given by ((Vnl-Vfl)/(Vnl)) X 100%. Typically Voltage at receiving end is known to us and for the sending end Vnl is given by Vs/A. Where A is given by the ABCD parameters of the transmission line and Vs = AVr + BIr.
Line regulation is a measure of the ability of the power supply to maintain its output voltage given changes in the input line voltage. Line regulation is expressed as percent of change in the output voltage relative to the change in the input line voltage.
Line refers to the a.c. supply line. Line regulation is the change in output of a device, usually a power supply, which is due to variations in the voltage of the a.c. supply.
how to fix a transmission without taking it a part how to fix a transmission line
Line regulation defines as the output voltage of the zener to remain constant under input line variation. Load regulations defined as the load increases or decreases the zener will control this variation by keeping the voltage constant.
Only if it is a DC transmission line.
It does not depend on the line. The regulation is the percentage change in voltage caused by applying the full load current, and that depends on the transformer supplying the line. A value of 5% would be typical.
If this vehicle has a transmission cooler then it will have one line to the cooler then another for the return line to the transmission.
The end line
No, but transmission line act as a lpf
how much to replace the transmission line in 2006 Chevy impala