hit it with a hammer
how do you change a headlamp on a Toyota rav 4
Phillips screwdriver from the front
The horn on a 1997 Toyota Rav 4 can be replaced. To replace it located the horn on the inside of the bumper. Loosen the mounting bolts and unplug the wiring. Replace the unit.
YOU DONT. ITS A CHAIN.
Very carefullyJimmy out!
1. Remove the battery and battery holder to gain access to the lamp. 2. Remove the electrical plug from the lamp. 3. Remove three Phillips screws that hold in the lamp. 4. Install replacement bulb. 5. Replace screws. 6. Reconnect electrical plug. 7. Replace battery holder and battery.
1: Remove plastic cover over headlight, 2:Pull or pry up the two tabs that secure lamp assy to car, 3: pull entire lamp assy forward, 4: Remove bulb retainer ring by twisting, 5: Remove bulb. Replace everything in reverse order.
To change fan belt on a Rav 4, remove the bolt in front of the engine. Loosen the pulley and gently pull away the fan belt. Replace with new.?æ
There are 4 little screws around headlight, remove then unplug and replace. Vdubwizard
To change the headlight bulb on a Pontiac Wave it is good to remember to not touch the new bulb with the fingers. Gently remove the headlight lamp cover (it should pop off after a gentle pull). Turn the old bulb and pull to remove it. Then, using the small plastic gripper (sold where headlights are sold) insert the new bulb and turn 1/4 turn. Replace the headlight lamp cover.
According to the Gates website ( they make timing belts etcetera ) For the 2.0 litre four cylinder engine in a 1997 Toyota RAV 4 ( 60,000 miles )
First make sure you have plenty of headlight fluid and blinker fluid. Then you need to use one of those left handed screw drivers to remove the bolts. Then make sure your 710 cap is screwed on tightly. If it is then check your donut exhaust to make sure u get proper flow.