Hold the speedo reset buton down when tirning on ignition after about 30 seconds it will reset.
Disconnecting the speed sensor stops the speedo and odometer. The odometer has to be changed by a certified speedo repair shop.
The timing light reset if i remember is behind the speedo. Remove the speedo head and clocks and look on the back. There should be a little jumper in some terminals and next to it there should be some empty terminals. Just remove jumper from one and put into other, this should reset timing belt light.
The timing light reset if i remember is behind the speedo. Remove the speedo head and clocks and look on the back. There should be a little jumper in some terminals and next to it there should be some empty terminals. Just remove jumper from one and put into other, this should reset timing belt light.
A combination of pulling and pushing the 2 speedo buttons at the same time. This should reset the service light.
A combination of pulling and pushing the 2 speedo buttons at the same time
You will need to pull out the instrument cluster and swap a screw on the back of the speedo unti. Best thing is to totally remove the mechanism on the back of the speedo which is only there for the cam belt light and throw it away.
Also some Vans have a small rubber Grommet on the clear plastic speedo (front). You pick it out and poke a small wire into the hole to reset.
If you meen the trip meter have the engine running press the right hand button at the bottom of the speedo until it goes to zero.
Turn trip reset button on cluster clockwise if that dont work check settings in cluster
yes, but the speedo will need to be reset and the fuel milage will drop
You can reset your trip milage by pressing the black stick/button below rev counter. The total milage can't be reset for obvious reasons. The other black stick to the left below the speedo is for twisting left or right to set the hours and minutes on your clock.