What year corvette? I have a 1989 Coupe and I removed the fuel door and the fuel boot and reached in through the access. You have to have skinny arms, though. It's a tight fit. I've read where some remove the inner fender, possibly the spare tire too or remove the rear fascia. Never tried those since I have skinny arms and can reach through after removing fuel door and boot.
Change brake light bulbs Just remove the rear license plate. You can change the backup lights and brake light easily.
It is possible that one of the bulbs is shorting out. Try replacing the brake light bulbs, if that doesn't work, troubleshoot the brake light switch.
The light assy has to be removed and the bulbs removed from the back.
Remove the two screws that hold the lens on, remove the lens and change the bulbs.
To change the brake lights on a 1997 Volkswagen Polo first locate the brake light housings in the trunk. Remove the plastic covers and unlock the bulbs. Remove the bulbs and install the new brake lights.
The brake light bulbs ar removed from the rear of the light assy . Take it off of the body.
Take the screws out of the lenses, remove the lense and replace the bulb.
Headlight bulbs, high and low beam, parking light bulbs, signal light bulbs, brake light bulbs, dash light bulbs, interior light bulbs, plate light bulbs, etc.
check light bulbs and fuses. light bulbs have 2 elements in them, one for stop and one for running. if thses are ok, replace brake light switch on brake pedal
If you mean the brake light, you just have to change the bulb or bulbs.
Change the bulb and check to see if it's not grounding out.
just above the brake peddle
back side of the brake pedal
Brake Light ColorMine are clear bulbs ["white"] light, but the bulbs are mounted in an assembly with a red lens.
I assume you only need to change the bulbs. Go into the trunk and look up. You should see the wires leading to the mounting point for the third brake light, you candisconnect the connectors and then change the bulbs this way.
check your bulbs
The daytime run lamps are your high beam bulbs with a module that cuts the amount of amperage that just dims the bulbs. Just change high beam bulb.
Put this question into google, and you will find many reasons and remedies to this problem. Ei...brake light switch, brake light bulbs, including the upper brake light bulbs.
If you are referring to the right and left ones, pull the carpeting away and you will find like 4 nuts that you remove and the whole assembly comes out to change the bulb or bulbs. The 3rd brake light in the rear window has two bulbs which you get to from the trunk. If you are referring to the right and left ones, pull the carpeting away and you will find like 4 nuts that you remove and the whole assembly comes out to change the bulb or bulbs. The 3rd brake light in the rear window has two bulbs which you get to from the trunk.
If it is just one brake light, the chances are good that it is the bulb. Bulbs are cheap.
To change the brake light bulb on a 1999 Honda Passport find the light housing located in the trunk. Find the plastic covers for the lights and remove them. Pull the bulbs out carefully and replace them.
Remove the lense from the car then you will find a holder with all the bulbs in. change which ever bulb
tail light bulbs has two filaments inside. One for regular lights and a second for brake lights. One filament is burnt out. Change the bulb.
Unlike the two standard brake light bulbs, which are generally changed from behind, a 'third' brake light is usually changed from the front. Locate the lens mounting screws and remove them; the bulb should then be revealed.
The # is 1157 bulbs.