2.2L OHV Engines * Drain coolant (about 1 gallon) from the radiator until its below the thermostat housing * Disconnect the radiator hose from the thermostat cover * Remove the bolts and lift the cover off you mat have to tap the cover with a soft-face hammer to loosen it * Not how its installed then remove the thermostat 2.3L and 2.4L OHC Engines * Drain the coolant from the radiator * Remove the exhaust manifold heat shield * Remove the cover that protects the outlet pipe on the thermostat housing by accessing cover bolts through the exhaust manifold runners * Raise and secure the car on jackstands * Disconnect the radiator hose from the metal outlet pipe * Remove the outlet pipe bolt and carefully separate the outlet pipe from the thermostat housing and the engine block * Note how its installed then remove the thermostat from the outlet pipe
depends on the engine size
It is at the engine end of the top radiator hose.The housing is the thermostat housing and the thermostat is located therein.
Right at the engine head, where the top radiator hose meets it. That is the thermostat housing. Clean it real good when dismantling and replace the new thermostat with the spring facing the engine.
Changing the thermostat on a 2002 Chevrolet 4.8 liter engine is simple to do. First, follow the upper radiator hose to the thermostat. Then drain the radiator hose. After the hose is drained, remove the clamps and bolts holding the thermostat housing in place. Then remove the old thermostat and replace with a new one.
The thermostat on a 1999 2,4 liter Grand Am is located on the side of the engine. The thermostat is on the drivers side of the engine a few inches from the top.Ê
What causes a 1997 Pontiac sunfire gt with a 2.4 liter engine to stall when stopped at a light
The thermostat is under the housing where the lower radiator hose attaches to the engine.
Yes, you can replace a 1.5 liter engine in a 1997 Mirage with a 1.8 liter engine. However, there will be extra parts needed to modify the engine so that it will fit perfectly.
in front of the engine above the water pump
On the 2.6 liter, 4 cylinder engine the thermostat housing cover is where the upper radiator hose attaches to the engine. On the 3.0 liter, V6 engine the cover is where the lower radiator hose attaches to the engine.
The thermostat is under the housing where the upper radiator hose attaches to the engine.
The thermostat is located under the housing that the lower radiator hose hooks to on the engine.