How to enter gameshark codes on vba?

Answer 1

well, the way I've done it, it work fine, you make sure that you have either a word or whatever document or a website up with the cheat codes for your game then you pull up the GBA emulator, and select your game like you would normally do and there should be at the top after your game is loaded a section labeled cheats then you go to cheat list and then it should say add GameShark code so you press the button and enter the name at the top and enter in the code, now it will be enabled right away, so if you don't want it on yet then uncheck it,then when you are done you press the red X and you will go back to your game if you want to check or uncheck some thing or put a new code in just go back up to the cheat section and do it over again, and you have to save your game the way like when it says wrote slot 1 down at the bottom or you will have to enter in your codes again when you start the game again. and the only game where the cheats didn't work for me was megaman battle network 3 blue but i think that it's just the codes.

Answer 2

There is a cheat menu at the top.

Under this menu there is an option that has the option cheat list.

click this option then select the option gameshark

the first box is to set the code description

the big box is to set the code or codes that will be set for the game,

Normally a MASTER CODE then another box for the selected cheat.

Answer 3

Look on the top of the emulator you can see a couple things to click on, click on Cheats and then Cheat List (you cannot click on cheat list until you load a rom) then click ADD NEW then enter the code in the big half you can optionally put a description of what the code actually does then press OK.

Answer 4

dando o cu