Step one of one: get smart noob.
passenger seat cable its under seat drive cable
It seems that you cannot. I have an S class. As the seat adjusts forward and back a cable makes the seatbelt go up and down. I think mu=y drivers cable is broken, there is no manual adjustment
you can't... i tried.
To install a rear seat belt on a Mercedes C180 estate, first, ensure you have the correct replacement seat belt for your model. Remove the rear seat cushion and side panels to access the mounting points. Secure the new seat belt by attaching it to the designated anchor points, ensuring they are tightened properly. Finally, reassemble the seat and side panels, and test the seat belt for proper functionality.
There is an electrical connector located under sear that connects to seat belt buckle, just disconnect it.
I can assume that you are talkin about centre belt cause they seem to be a big problem. First of all before you go there , there is a cable that runs from the seat belt unit to the catch that your seat clips into when you have laid it down. You will probably find that the seat catch is not engaged properly which stops a cable from retracting and allowing the seat belt mechanism to release. Try lubricating the latch at the rear of the seat and also slamming. This is a safety device so if your seat is not clipped in properly you cannot pull out seat belt. If this doesn't work - Unclip the the rear protector on the rear of your seat and you will see along the edge of the seat near the bottom ,where you undo the fabric from the seat . Fold the fabric at the top away after unclipping the plastic insert were the belt goes into the seat, You will see some screws holding a steel plate over the belt. Remove the plate - Look on the back of the seat on the steel part and there is a bolt holding seat belt in place , Undo this and abstract seat belt from between foam and release cable from seat belt..
To remove the seat belt in a 1999 Ford Fiesta, start by locating the seat belt buckle and the retractor. Use a screwdriver to remove any screws securing the plastic cover around the retractor and the buckle. Once the cover is off, unbolt the seat belt from its anchor points using a socket wrench. Finally, gently pull the seat belt out of the retractor and remove it completely from the vehicle.
yhere is a seat belt module under middle front seat try disconnect battery first that worked for me
To remove the passenger side front seat belt in a 1999 Toyota Corolla, first, ensure the vehicle is turned off and the seat is in a forward position. Locate the seat belt anchor bolt at the base of the B-pillar and use a socket wrench to remove it. Next, detach the seat belt from the retractor mechanism by accessing the rear side panel if necessary and unbolting it. Finally, pull the seat belt free from its guides and clips.
My 97 has pre tensioners. I see no reason for the 99 to not have it. Do you mean the seat belt has an automatic retracton? If so, the answer is yes.
You put the buckle in the clasp. Where your seat belt you paid for it and it will save your life. or u can do this: under the seat their is a cable connected it ends are purple on it disconnect them that should do it as i have jetta a vw jetta
Check to see if anything restricting movementCheck to see if cable disconnected or brokenSee if you can manually move cable to lower seat