go to autozone.com,look up 92 Nissan stanza,engine size and look up clutch slave cylinder,then to the right of screen ,look up repair guide and it will show and tell you how to.
answer
unscrew the pipe fluid line unscrew bolts,remove ,apply some good grease on the end ball of the cylinder install new one,bleed the system slowwly verry well
To bleed a clutch on a Nissan Stanza, you need to find the bleed-off valve, usually somewhere near the slave cylinder.
The 1990 Stanza only came with a 4 sylinder.
buy american
go to transmission and unsrew line from slave cylinder and drain fluid into container,remove two bolts holding it on,install new part with two bolts and tighten line up,fill clutch master cylinder up with dot 3 brake fluid and bleed,pump clutch pedal a couple of times and have someone open line to let air out,good luck...
If it is a four cylinder it will be: 1 3 4 2
Four Cylinder is: 1 3 4 2
Nissan Stanza was created in 1977.
Attached to body behing brake pedal (if automatic) clutch pedal (if standard)
Drain the water from your 1987 Nissan Stanza. Remove the water return hose from the water pump. Remove the water pump retaining bolts. Reverse the process to install the new water pump.
You will need to remove the tire and wheel from your 1992 Nissan Stanza. Remove the brake pad spring and caliper. The brake assembly will come off. Reverse the process to install the new brake pads.
The 1989 Nissan Stanza 2.0 4 cylinder has a timing belt. This is also an Interferance Engine, and as such if the belt breaks, serious engine damage will occur. The belt should be replaced at 60,000 miles.
5W30 5W40 10W30 are all recommended for Nissan Stanza