Want this question answered?
Yes
remove the right front wheel, then you can see it, tough to get at.
The 2000 Chevy Corvette normal operating coolant temperature is 195 degrees. You can install thermostats that will allow the coolant temperature to only run at 180 degrees.
How do you install a stsrter on a 1995 eldorado caddy
In many cases for this generation, your top cover has a total of 12 screws with a torx head on them. Remove those and you will see the sensor to the right. Replace and re-install.
how to install a maf sensor on a cadillac deville concours?
Unplug electric connector. Sensor is in water jacket so you will need to catch coolant after removing sensor. Properly dispose of old coolant. Install new sensor and just make a little snug (with open-end wrench)- do NOT over tighten. Install electric connector and top off coolant.
How to install a coolant temperature senThe only one I've ever changed was on a 3.1 litre V6 and it's located right behing the thermostat housing. All you need to do is unplug the clip with 2 wires and unscrew the sensor from the block (usually with a 1/2 inch end wrench). Installation is just the opposite.
You probably have a bad coolant temperature switch, this are fairly cheap and easy to install.
Only do this with a cold engine! Hot coolant will scald you! 1. Partially drain cooling system until coolant is below thermostat housing level.2. Disconnect hose from thermostat housing.3. Disconnect electrical connections from coolant temperature switch.4. Remove bolts securing housing.5. Remove thermostat.Refit:1. Clean off old gasket from housing and/or engine.3. Install new thermostat with copper element(spring) towards engine.(Note: If your thermostat has a hole in the ring, install with hole at the top(12 noon) position)4. Install new gasket.5. Install housing.6. Install hose and clamps.7. Install electrical connection(coolant temperature switch).8. Refill coolant to proper level.9. Check for leaks. Retighten as necessary.
The 1995 Cadillac Eldorado drivers side door panel is held in place by eight retaining clips. Pry outward on each retaining clip. The door panel will come off. Remove the linkage from the power window motor. Remove the wiring harness from the power window motor. Remove the retaining bolts. Reverse the process to install the new power window motor.
If you are talking about the low coolant light then it is just low of coolant. If you are talking about the coolant temperature light, then the engine is overheating. This car is 7 years old. Have the cooling system serviced. Drain the coolant and flush the system. Install a new thermostat, and add a 50/50 mix of antifreeze and distilled water.