Best Answer

Providing that you have a stock Vehicle ignition system, we just put a tach on our 90 350 and there are two plugs on the coil, a single wire comes from the fire wall, the other has two wires and comes from the dist, out of that plug there is a short wire pig tail that is just hanging there and it has a protected male terminal on the end of it , plug your applicable tach sensor into that connection and follow the tach install instructions to hook up your lighting and ignition wires. Most new tachs come with installation instructions. Happy Reving

User Avatar

Wiki User

โˆ™ 2008-05-18 23:26:02
This answer is:
User Avatar
Study guides
See all Study Guides
Create a Study Guide

Add your answer:

Earn +20 pts
Q: How to install a tachometer on a 1994 Chevy 350 tbi?
Write your answer...
Related questions

Will a 1978 Chevy 350 Carborator intake interchange with a 1994 Chevy 350 carborator intake?


How to install a Chevy 350 into a Honda Passport?

Don't do it because it's not a Chevy.

Where do you install the oil pressure gauge on a Chevy 350 small block?

how to install the oil pressure gauge on a Chevy 350 small block

What type of 350 engine is in the 1994 c1500 Chevy truck?

350 tbi

How do you hook up tachometer to a Chevy 350 that does not have HEI distributor?

Connect the green wire to the negative side of the coil.

Where is the oil plug on a 1994 Chevy 350?

The oil drain plug on a 1994 Chevy 350 is on the underside of the motor. Look for a bolt in the very center of the bottom of the engine.

Can you put your Chevy 350 1994 intake on a LS 1 Chevy 350 block will it work?

no completely different motor

Does a 1994 Chevy 350 have a 02 sensor?


Will a 1988 Chevy 350 out of a camaro work in a 1994 Chevy Tahoe chassis?


What is the 1994 Chevy 5.7L v8?

350 cubis inch

Bolt pattern for 1994 Chevy k1500?

350 i think.

What is stock cc of 1994 Chevy 350 head?


350 300 hp Chevy crate motor what do you have to do to install into a 1994 Chevy 1500 throtle body 305?

The 350 and the 305 is a direct swap, The only thing that is different with the 305 is the size of the pistions, They are smaller then the 350 engine. Just transfur the intake and all the other parts from the 305 and put it all on the 350 engine. Easy job.

What is the spark plug gap for 1994 Chevy 5.7 350?


Can you swap a Chevy 350 into a 1994 toyta pick up?


What is the spark plug gap on a 1994 Chevy 350 suburban?


Is a 1994 Chevy 4wd 350 truck motor a vortec motor?

No it is not.

What is the fuel ratio of a 1994 Chevy 350?

ideally, 13.7-1

Can you install a 350 Chevy engine into 06 charger?

If you have enough time and money you can... but why?

How much torque does a stock 350 from a 1994 Chevy 4x4 have?

A stock 350 cubic inch engine in a 1994 Chevy 4 x 4 will put out 310 foot pounds of torque. It does this at 2400 rpm.

Will transmission out of a 1994 Chevy truck fit in a 1991 Chevy suburban both have 350 engines?


Can you take a 1994 Chevy caprice 350 LT1 and put it into your 1993 Chevy Suburban 350 TBI after you switch intakes and put in the distributor?

Yes you sure can

Timing deg for 1994 Chevy k1500 4x4 350?

all Chevy tbi's are to be set at 0 degrees

Can a 1994 Chevy 350 intake will it fit 1974 Chevy 350?

No. Not without switching the cylinder heads. I think it was 89, Chevy came out with the 1st generation Vortec heads, which require a different intake.

How can i get more power out of your 350 vortech Chevy truck?

Install a Super-Charger or Turbocharger.