Start by removing the little plastic caps over the screws on the track guards in back, on the floor. Then, remove the screws(T20's, or Phillips), and then lift, and remove the track guards. The seat is mounted on these tracks, and a central rail that is held to the seat. So, to release the central rail the fasteners used ALMOST always is a 13mm hex head bolt, but once I found a pair of Torx bolts used, and they were a T-30, or T-40. One bolt per side of the central rail. Then just push strait back on the seat, and it will release. It may take a little persuasion, but if you push on the seatback, right at the base it should eventually move out freely. The next thing necessary to do is to remove the electrical fasteners/connectors. One for the side air bag, one for the seat heater, and one for the seat belt switch showing that the seat belt is engaged. All of the wires come through the carpet at a central location right under the front of the seat. I usually lay the seat back on the front edge of the rear seat, and get the connectors apart, but first you'll have to get the seat out of the track completely(there's just enough wire to do that), lift the seat track wheels up above the seat track, pull it forward a little, and set it down on top of the seat rails. Then you'll be able to lay the seat back on the rear seat. Remove the connectors. Then, remove the seat from the car. DON'T TURN THE CAR ON with the seat out. It will set an airbag fault that you CAN'T clear unless you take it to the dealer
remove passenger seat in 2003 cadillac cts
You have to remove the Allen bolt on the rear of the passenger seat, then remove the two Allen bolts exposed when you removed the passenger seat. The driver seat should slide back and off now.
Remove front passenger seat on Lexus es300?
how to remove front passenger seat of 1996 Honda Civic EX 2 door coupe
You have to remove the 28 mm bolts at the rear of the passenger seat on either side of the tail light. Now slide the passenger seat back to release a clip holding the front edge of the passenger seat. Then remove the 12 mm bolts holding the seat to the frame.
You have to remove the carpeting and the panels on the passenger side of the car.
A front passenger seat on a 2005 Honda Civic is held on by four bolts. Pull the seat back to loosen the front two. Pull the seat forward to reach the two rear bolts. Remove the seat.
the folding tray OS bolted to the passenger seat. the passenger seat must be removed in order to unbolt the tray from the seat.Do not remove the passenger seat. remove the cover that attached to metal bracket of p. seat. it's mounted with two plastic screws. use flat screw driver to remove. then you will see 3 bolts on the bracket attached to p. seat. remove bolts and pull away.
how do you reset the passenger side airbag on a 2000 passat?
remove the passenger pad first, when removed it uncovers screws on the rear of the drivers seat. Remove these and it comes off.
Should be a bolt in each corner of the seat
yes the front two doors speakers are 6.5 and the back passenger seat speakers are 5.25 .